Abstract:This paper presents a high quality-factor (Q-factor) quartz tuning fork (QTF) with a glass probe attached, used in frequency modulation tapping mode atomic force microscopy (AFM) for the surface profile metrology of micro and nanostructures. Unlike conventionally used QTFs, which have tungsten or platinum probes for tapping mode AFM, and suffer from a low Q-factor influenced by the relatively large mass of the probe, the glass probe, which has a lower density, increases the Q-factor of the QTF probe unit allowing it to obtain better measurement sensitivity. In addition, the process of attaching the probe to the QTF with epoxy resin, which is necessary for tapping mode AFM, is also optimized to further improve the Q-factor of the QTF glass probe. The Q-factor of the optimized QTF glass probe unit is demonstrated to be very close to that of a bare QTF without a probe attached. To verify the effectiveness and tire advantages of the optimized QTF glass probe unit, the probe unit is integrated into a home-built tapping mode AFM for conducting surface profile measurements of micro and nanostructures. A blazed grating with fine tool marks of 100nm, a microprism sheet with a vertical amplitude of 25 mu m and a Fresnel lens with a steep slope of 90 degrees are used as measurement specimens. From the measurement results, it is demonstrated that the optimized QTF glass probe unit can achieve higher sensitivity as well as better stability than conventional probes in the measurement of micro and nanostructures.

Tuning Forks As Micromechanical Mass Sensitive Sensors for Bio- or Liquid Detection

Quartz Tuning Fork Biosensor.

Ultrasensitive charge detection utilizing coupled nonlinear micromechanical resonators

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

Integrated tuning fork nanocavity optomechanical transducers with high $f_{M}Q_{M}$ product and stress-engineered frequency tuning

Chemical Sensor Based on Microfabricated Wristwatch Tuning Forks.

Determination Of Liquid Density With A Low Frequency Mechanical Sensor Based On Quartz Tuning Fork

A Mass Sensing Technology Based on a Dynamic Microcantilever in Liquid

Simultaneous Measurement System of Liquid Density and Viscosity Using Steel Tuning Fork

Enhancing responsivity and detection limit in tunable nano-electromechanical system resonator mass sensors

Research On The Sensing Performance Of The Tuning Fork-Probe As A Micro Interaction Sensor

Use of Torsional Acoustic Resonators for Microweighing, Polymer Rheology, and Monitoring of Biofilm Formation

A mechanical micro molecular mass sensor

Sensing Performance Analysis on Quartz Tuning Fork-Probe at the High Order Vibration Mode for Multi-Frequency Scanning Probe Microscopy.

Double Tuning-Fork Resonant Accelerometer

Sensitivity Manipulation on Micro-Machined Resonant Electrometer Toward High Resolution and Large Dynamic Range

Calibration of the oscillation amplitude of quartz tuning fork-based force sensors with astigmatic displacement microscopy

A novel colorimetric tuning fork sensor for ammonia monitoring

Equivalent Electromechanical Model for Quartz Tuning Fork Used in Atomic Force Microscopy

Sensitivity Dependence of Single Nanoparticle Mass Detection Using Mechanical Oscillations in Optical Microcavities

Effects of naloxone on the cardiovascular responses to muscular contraction in decerebrate cats