Abstract:In order to achieve desired mechanical properties of alloys by manipulating grain boundaries (GBs) via solute decoration, it is of great significance to understand the underlying mechanisms of microstructural evolution and plastic deformation. In this work, nanocrystalline (NC) Cu-W alloyed films with W concentrations spanning from 0 to 40 at% were prepared by using magnetron sputtering. Thermal stability (within the temperature range of 200 °C-600 °C) and hardness of the films were investigated by using the x-ray diffraction, transmission electron microscope (TEM) and nanoindentation, respectively. The NC pure Cu film exhibited substantial grain growth upon all annealing temperatures. The Cu-W alloyed films, however, displayed distinct microstructural evolution that depended not only on the W concentration but also on the annealing temperature. At a low temperature of 200 °C, all the Cu-W alloyed films were highly stable, with unconspicuous change in grain sizes. At high temperatures of 400 °C and 600 °C, the microstructural evolution was greatly controlled by the W concentrations. The Cu-W films with low W concentration manifested abnormal grain growth (AGG), while the ones with high W concentrations showed phase separation. TEM observations unveiled that the AGG in the Cu-W alloyed thin films was rationalized by GB migration. Nanoindentation results showed that, although the hardness of both the as-deposited and annealed Cu-W alloyed thin films monotonically increased with W concentrations, a transition from annealing hardening to annealing softening was interestingly observed at the critical W addition of ∼25 at%. It was further revealed that an enhanced GB segregation associated with detwinning was responsible for the annealing hardening, while a reduced solid solution hardening for the annealing softening.

Ordered Ground State Wurtzite Alloys from Zinc-Blende Parent Compounds

Alloy Stabilized Wurtzite Ground State Structures of Zinc-Blende Semiconducting Compounds

Ground-state Structure of Coherent Lattice-Mismatched Zinc-Blendea1−xbxcsemiconductor Alloys (X=

Pressure-induced Structural Transition of CdxZn 1 − Xo Alloys

Phase equilibrium of Cd 1– x Zn x S alloys studied by first-principles calculations and Monte Carlo simulations

The W alloying effect on thermal stability and hardening of nanostructured Cu-W alloyed thin films

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Investigation of W phase crystal structure and evolution mechanism based on Al-Cu-Sc alloy during homogenization

Structural Stability and Characteristics of the Metastable Ag-W Phases Studied by Ab Initio and Molecular Dynamics Calculations

First-principles Study of Wurtzitebc2n

Atomic site occupancy of alloying elements and Laves phase stability in γ-γ′ Co-base superalloys

Composition- and Band-Gap-Tunable Synthesis of Wurtzite-Derived Cu2ZnSn(S1–xSex)4 Nanocrystals: Theoretical and Experimental Insights

Electronic Structure and Phase Stability of Mgte, Znte, Cdte, and Their Alloys in the B3, B4, and B8 Structures

Zinc-Stabilized Manganese Telluride With Wurtzite Crystal Structure

Crystal structure and stability of phases in Mg-Zn alloys: A comprehensive first-principles study

First-principles Calculations of Mechanical and Thermodynamic Properties of Tungsten-Based Alloy

First-Principles Study Of Wurtzite Bc2n

First-principles study of the energetics and the local chemical ordering of tungsten-based alloys

Solidification Paths and Phase Components at High Temperatures of High-Zn Al-Zn-Mg-Cu Alloys with Different Mg and Cu Contents

Structural, Elastic, and Thermodynamic Properties of ZnSexTe1−x: A First-Principles Study

Theoretical insights into the crystal and fundamental properties of MgAl9Zn compound: First-Principles calculations