Abstract:Four kinds of sterically hindered groups-based hyperbranched polyfluorene copolymers containing different branching units such as benzene or triphenylamine were designed and synthesized.All the monomers such as 2,7-dibromo-9,9-dioctylfluorene,2,7-dibromospiro(fluorene-9,9′-xanthene), 9,9-dioctylfluorene-2,7-bis(4,4,5,5-tetramethyl-1,3,2-dioxaborolane) and 9,9-dioctylfluorene-2-boronic acid were prepared according to the literature procedures.Suzuki polycondensation (SPC) with the branching units and linear units was conducted in biphasic system (toluene/aqueous Na_2CO_3) with Pd(PPh_3)_4 as a catalyst precursor.The reaction mixture containing monomers was kept stirring at 72℃ under nitrogen for 60 h at the polymerization stage.Then,the end-capped group was added to the reaction mixture together with additional Pd(PPh_3)_4 in order to reduce the heavy atom effect which quenched fluorescence.The reaction was continued for further 12 h.After cooling to room temperature,some amount of thiourea was added,and then the mixture was vigorously stirred for another 3 h.The mixture was filtrated to remove the catalyst residues and extracted with toluene.After removal most of the solvent,the crude polymer in certain amount of toluene was added dropwise to methanol and the formed precipitate was recovered by filtration.The solid was washed with methanol,water and again with methanol,then followed by Soxhlet extraction with acetone for 48 h to remove oligomer.The yellow powder was collected and dried under vacuum.All the resulting hyperbranched copolymers are soluble in common organic solvents,such as tetrahydrofuran,chloroform and toluene.The structures of the hyperbranched polymers were fully characterized by NMR,GPC,elementary analysis and thermogravimetric analysis.The degrees of branching of the polymers were calculated through the integration of the characteristic signals of the branching units and linear units from the high-resolution NMR spectroscopy.The GPC experimental results showed that the number-average molecular weights of the polymers were from 11200 to 17200.The thermal degradation temperatures (weight loss 5%) of the polymers were nearly at 400℃.Cyclic voltammetry (CV) was used to assess the electrochemical behavior of the polymers.The polymers show a reversible oxidation/reduction wave which can be assigned to the oxidation/reduction potential of copolymer main chain from the onset.The HOMO level of the polymer containing triphenylamine is lower than that containing benzene,which indicated less difficulty in hole injection.The photophysical characteristics of the polymers were investigated in solution and in solid films.Solid films on quartz plates used for UV-Vis,fluorescence were prepared by spin-coating with 10~ -3 mol/L tetrahydrofuran solution.The absorption maxima of the polymers are blue-shifted within 10 nm compared to that in solution.In addition,the PL maxima remain unchanged or are only slightly red-shifted.Their thermal stability was investigated from the change of fluorescent spectra in solid films after annealing at elevated temperature in air.There was no obvious change in the PL spectra,and no additional green-blue band emission was observed even after the film was annealed at 200℃ in air.Apparently,with the introduction of spirofluorene/large aromatic units to the hyperbranched structure,the red-shifted phenomena and the undesirable low-energy long wavelength emission band are reduced remarkably.All results indicated that the tendency to form aggregate/excimers in the solid state was efficiently suppressed,and the spectral stability of the polymers was greatly improved.

Synthesis and Photophysical Properties of Conjugated Poly(9,9-Dialkylfluorenolbenzobisoxazole)S

Synthesis and Properties of a Novel Bio-based Benzoxazine

Synthesis and performances of 9,9‐bis(perfluorohexylethyl propionate) fluorene copolymers

Synthesis of benzothiadiazole-9,9-bis(perfluorohexylethyl propionate) fluorene copolymers with enhanced photoluminance stability

A fluorescent copolyimide containing perylene, fluorene and oxadiazole units in the main chain

Preparation, Characterization, and Properties of Fluorene‐containing Benzoxazine and Its Corresponding Cross‐linked Polymer

Spectral And Thermal Spectral Stability Study For Fluorene-Based Conjugated Polymers

Synthesis and Nonlinear Optical Properties of Copolymers of Fluoro-Containing Bisphenol A and Chromophores

Spectroscopic properties of poly(9,9-dioctylfluorene) thin films possessing varied fractions of β-phase chain segments: enhanced photoluminescence efficiency via conformation structuring

Synthesis of Heat-Resistant Benzoxazine-Based Polyfluorene and Its Reversible Temperature-Sensitive Fluorescence

Fluorene and Silafluorene Conjugated Copolymer: A New Blue Light-Emitting Polymer

New Series Of Blue-Emitting And Electron-Transporting Copolymers Based On Fluorene

Synthesis, Photophysics, and Electroluminescence of Poly(Dibenzofluorene)S

Synthesis, Characterization and Thermal Stability of Hyperbranched Polyfluorenes Containing Sterically Hindered Groups

Effect of Fluorenone on the Polyfluorenes with Polar Tri (ethylene Oxide) Side Chains and Their Synthesis, Characterization and Photophysics

Effect of fluorine atoms on optoelectronic, aggregation and dielectric constants of 2,1,3-benzothiadiazole-based alternating conjugated polymers

Effect of Fluorenone Units on the Property of Polyfluorene and Oligofluorene Derivatives: Synthesis, Structure−Properties Relationship, and Electroluminescence

Fluorene-Based Light-Emitting Polymers

Synthesis and photovoltaic properties of an alternating polymer based fluorene and fluorine substituted quinoxaline derivatives

Side-chain Effect on the Structural Evolution and Properties of Poly(9,9-Dihexylfluorene-alt-2,5-dialkoxybenzene) Copolymers.

Theoretical Studies of the Absorption and Emission Properties of the Fluorene-Based Conjugated Polymers