Abstract:Four kinds of sterically hindered groups-based hyperbranched polyfluorene copolymers containing different branching units such as benzene or triphenylamine were designed and synthesized.All the monomers such as 2,7-dibromo-9,9-dioctylfluorene,2,7-dibromospiro(fluorene-9,9′-xanthene), 9,9-dioctylfluorene-2,7-bis(4,4,5,5-tetramethyl-1,3,2-dioxaborolane) and 9,9-dioctylfluorene-2-boronic acid were prepared according to the literature procedures.Suzuki polycondensation (SPC) with the branching units and linear units was conducted in biphasic system (toluene/aqueous Na_2CO_3) with Pd(PPh_3)_4 as a catalyst precursor.The reaction mixture containing monomers was kept stirring at 72℃ under nitrogen for 60 h at the polymerization stage.Then,the end-capped group was added to the reaction mixture together with additional Pd(PPh_3)_4 in order to reduce the heavy atom effect which quenched fluorescence.The reaction was continued for further 12 h.After cooling to room temperature,some amount of thiourea was added,and then the mixture was vigorously stirred for another 3 h.The mixture was filtrated to remove the catalyst residues and extracted with toluene.After removal most of the solvent,the crude polymer in certain amount of toluene was added dropwise to methanol and the formed precipitate was recovered by filtration.The solid was washed with methanol,water and again with methanol,then followed by Soxhlet extraction with acetone for 48 h to remove oligomer.The yellow powder was collected and dried under vacuum.All the resulting hyperbranched copolymers are soluble in common organic solvents,such as tetrahydrofuran,chloroform and toluene.The structures of the hyperbranched polymers were fully characterized by NMR,GPC,elementary analysis and thermogravimetric analysis.The degrees of branching of the polymers were calculated through the integration of the characteristic signals of the branching units and linear units from the high-resolution NMR spectroscopy.The GPC experimental results showed that the number-average molecular weights of the polymers were from 11200 to 17200.The thermal degradation temperatures (weight loss 5%) of the polymers were nearly at 400℃.Cyclic voltammetry (CV) was used to assess the electrochemical behavior of the polymers.The polymers show a reversible oxidation/reduction wave which can be assigned to the oxidation/reduction potential of copolymer main chain from the onset.The HOMO level of the polymer containing triphenylamine is lower than that containing benzene,which indicated less difficulty in hole injection.The photophysical characteristics of the polymers were investigated in solution and in solid films.Solid films on quartz plates used for UV-Vis,fluorescence were prepared by spin-coating with 10~ -3 mol/L tetrahydrofuran solution.The absorption maxima of the polymers are blue-shifted within 10 nm compared to that in solution.In addition,the PL maxima remain unchanged or are only slightly red-shifted.Their thermal stability was investigated from the change of fluorescent spectra in solid films after annealing at elevated temperature in air.There was no obvious change in the PL spectra,and no additional green-blue band emission was observed even after the film was annealed at 200℃ in air.Apparently,with the introduction of spirofluorene/large aromatic units to the hyperbranched structure,the red-shifted phenomena and the undesirable low-energy long wavelength emission band are reduced remarkably.All results indicated that the tendency to form aggregate/excimers in the solid state was efficiently suppressed,and the spectral stability of the polymers was greatly improved.

Synthesis of benzothiadiazole-9,9-bis(perfluorohexylethyl propionate) fluorene copolymers with enhanced photoluminance stability

Synthesis and performances of 9,9‐bis(perfluorohexylethyl propionate) fluorene copolymers

Synthesis of blue light emitting copolymers by oxidative coupling reaction

Synthesis, Characterization, and Electroluminescence of Novel Copolyfluorenes and Their Applications in White Light Emission

Synthesis and characterization of novel fluorene–based green copolymers and their potential application in organic light-emitting diodes

Novel blue-light-emitting truxene-containing hyperbranched and zigzag type copolymers: Synthesis, optical properties, and investigation of thermal spectral stability

Synthesis, Characterization and Thermal Stability of Hyperbranched Polyfluorenes Containing Sterically Hindered Groups

Effect of Fluorenone Units on the Property of Polyfluorene and Oligofluorene Derivatives: Synthesis, Structure−Properties Relationship, and Electroluminescence

Effect of Fluorenone on the Polyfluorenes with Polar Tri (ethylene Oxide) Side Chains and Their Synthesis, Characterization and Photophysics

Effect of fluorine atoms on optoelectronic, aggregation and dielectric constants of 2,1,3-benzothiadiazole-based alternating conjugated polymers

Synthesis and voltage-controlled multicolor electroluminescent property of copolyfluorenes containing a pendent anthraquinone-2,3-dicarboxylic imide

New Series Of Blue-Emitting And Electron-Transporting Copolymers Based On Fluorene

Synthesis and Electroluminescent Properties of the Copolymers of Fluorene and Dibenzothiophene

Syntheses, characterization, and energy transfer properties of benzothiadiazole-based hyperbranched polyfluorenes

Spectral And Thermal Spectral Stability Study For Fluorene-Based Conjugated Polymers

Highly Soluble Diphenylfluorene‐based Cardo Copolyimides Containing Perylene Units

Fluorene and silafluorene conjugated copolymer: A new blue light-emitting polymer

Benzodithiophene/Benzothiadiazole-Based ADA-Type Optoelectronic Molecules: Influence of Fluorine Substitution

Fluorene-Based Light-Emitting Polymers

Efficient Improvement of Fluorescence Quantum Yield of Fluoreneethynylene-Based Polymers by Introducing a Perfluoroalkylbenzene Unit to the Polymers

Synthesis of Heat-Resistant Benzoxazine-Based Polyfluorene and Its Reversible Temperature-Sensitive Fluorescence