Abstract:In a sheet forming process, drawbead plays an important role on the control of the material flow. In this paper, a numerical procedure for the design of forming processes is described. It is based on the coupling of an optimization technique and the simplified one step finite element method (also called inverse approach). The optimization technique allows adjustment of the process parameters so that specified criteria are fulfilled. Response surface methodology (RSM) is a global approximation method, which is ideally suited for solving highly nonlinear optimization problems. The finite element method, in addition to predicting the response of the process to certain parameters, allows assessment of the effect of a variation in these parameters on this response. The authors utilize the one step method at the preliminary design stage to supply stress or strain information for the following optimization using RSM. The procedure for this optimization process is fully described. The front fender for Numisheet 2002 is presented and the real defect free workpiece is produced to demonstrate the usefulness of the proposed optimization procedure. A comparison between the two forming limit curves (FLC) before and after optimization and results obtained using the precise incremental commercial software DYNAFORM based on the explicit dynamic approach verify that the optimization design method of drawbead could be successfully applied in designing actual tools of auto body cover panels.

FEA analysis and improvement design of deformation of refrigerator side-panel

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Numerical Study on Predicting and Correcting Assembly Deformation of a Large Fuselage Panel During Digital Assembly

COMPUTER AIDED DESIGN OF REFIGERATOR CONDENSER

Finite Element Study on Mechanical Performances of Multi-Span Metal Faced Sandwich Panels under Temperature Actions

Vacuum Forming Refrigerator Inner Liner Structural Optimization

FEA of solid plate weight-reduction design of large-scale magnesium alloy die cast machine

Finite element analysis of the thin-wall components’s deformation during the multi point flexible processing

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

STUDY ON THE DESIGN METHOD FOR STEEL STRUCTURE HEATING FURNACE IN PETROCHEMICAL INDUSTRY

Application of FEM Software ANSYS to Pipes Design of Air-Conditioner

Heat path analysis for hot-wall condensers of household refrigerators

Experimental Study on Performance Improvement of a Household Refrigerator with a Flying-Wing Evaporator

Deformation Analysis in Horizontal Stabilizer Assembly Using FEA Modeling and Multilevel Analysis

Effect of elastic deformation on the heat transfer characteristic of refrigerator gasket based on static analysis of structural assemblies

The Improved One Step FEM and Its Application in Sheet Metal Forming Analysis

Research on Air-Duct Optimization and Temperature Uniformity Analysis of Domestic Frost-Free Refrigerator-Freezer

Design and Analysis of Cold Stamping Process for the Car Beam Left/Right Section

Optimization of Drawbead Design in Sheet Forming Using One Step Finite Element Method Coupled with Response Surface Methodology

Structure Improvement Design for Upper Beam of Forging Machine Based on FEA