Simultaneous Determination of Two Active Ingredients in Dioscorea Nipponica Maknio from Different Origins and Ecological Conditions

ZHANG Nan,KANG Ting-guo,YIN Hai-bo
DOI: https://doi.org/10.13193/j.archtcm.2011.03.128.zhangn.056
2011-01-01
Abstract:Objective: To develop a HPLC method for the determination of Protodioscin and Dioscin in the rhizome of Dioscorea nipponica M.and establish an aggregative indicator to evaluate the quality of the crude drug.Methods: Samples were achieved and separated by Agilent TC-C18 column(250 mm×4.6 mm,5 μm)with acetonitrile-water as mobile phase for gradient elution.The flow rate was 1.0 mL·min-1.The column temperature was 35 ℃,the UV detector was set at 203 nm.There were 35 samples from different origins had been tested,and the contents of Protodioscin and Dioscin had been calculated following the linear calibration.Correlate analysis and principal component analysis were applied to study a new aggregative indicator.Results: The two saponins were well-separated.The linear calibration curve was obtained in a wide concentration range(r=0.999 8).The average recoveries of saponins were well;Pearson correlation coefficient is-0.615,the two indexes were moderate negative correlated.One principal component was extracted,which can represent more than 80% information of the two saponins and the scores can be calculated rapidly.Conclusion: The method is simple,accurate and reproducible.The principal component score is proposed to be used for the quality control of Dioscorea nipponica M..
What problem does this paper attempt to address?