Abstract:Applying pre-strain can not only change the microstructure and the mechanical property of metal material but also affect sheet metal stamping ability. In this paper, taking H260 low-alloy steel and TA2 titanium alloy as experimental materials, pre-strain ranging from 0 to 0.16 was applied using the one-step and the multi-step method respectively. Microstructure observation, tensile test, bending test, and cup bulging test were conducted on the pre-strained samples. Results show that in the pre-strain loading stage, the slipping and twinning deformation occurs in the TA2 alloy sample while dislocation sliding mainly happens in H260 low-alloy. With pre-strain increasing, the product of ultimate tensile strength and elongation rate gradually decreases, and the true ultimate tensile stress and accumulating elongation change rarely. The “product of yielding strength and elongation rate” can be enhanced by applying a pre-strain of 0.04 on the condition that plasticity is still at a high level. In the pre-strain range of 0 - 0.16, a bending test with a 30.8 °-opening angle can be completed on H260 steel. The springback angle changes from negative to positive with an increase in pre-strain. The bending ability of TA2 titanium alloy is very poor, for a crack can easily occur even in the original sample. The cupping value decreases gradually with an increase in pre-strain. The cupping value of TA2 titanium alloy is higher than that of H260 low alloy steel for the constant pre-strain. A quite large difference exists between the two experimental materials. Pre-strain loading pass has no significant effect on the microstructure evolution, mechanical properties, and stamping properties.

Combination of Strength and Plasticity of a Low Alloy Steel after Torsional Prestrain

Study of Plastic Hardening-Large Deformed Torsion Test and Simulation

Enhancing Strength and Plasticity Synergy in Transformation-Induced Plasticity-Aided Lean Duplex Stainless Steel Based on the Ultrafine-Grained Austenite

Seismic Behavior of Steel Tube Confined RC Columns under Compression-Bending-torsion Combined Load

Influences of pre-torsion deformation on microstructure and mechanical properties of pure titanium subjected to subsequent tension deformation

Abnormal Relation Between Tensile and Fatigue Strengths for a High-Strength Low-Alloy Steel

Extraordinary strain rate softening of metals in torsion

Mechanisms of strength–plasticity enhancement and stress-induced phase transition in a medium-carbon low-alloy steel

Effect of Pre-Strain on Microstructure and Stamping Ability of TA2 Titanium Alloy and H260 Low-Alloy Steel

Quantitative analysis of strength and plasticity of a 304 stainless steel based on the stress-strain curve

Evading the Strength–ductility Trade-off Dilemma in Steel Through Gradient Hierarchical Nanotwins

Effect of pre-strain on mechanical properties and hardening behavior of TRIP steel

Improvement of Strength-Toughness-Hardness Balance in Large Cross-Section 718H Pre-Hardened Mold Steel

Combining multiscale structure and TRIP effect to enhance room temperature tensile properties of 304 stainless steel by cryogenic cyclic plastic strengthening

Experimental Investigation on a Novel Medium Mn Steel Combining Transformation-Induced Plasticity and Twinning-Induced Plasticity Effects

Study of Microstructure and Mechanical Properties by Torsional Behavior in Axial Closed Die Rolling Forming

Strength and Strain-Hardening Enhancement by Generating Hard Delta-Ferrite in Twinning-Induced Plasticity Steel

Study on the mixture strain hardening of multi-phase steels

Effects of tensile prestrain on the notch toughness of low-alloy steel

Cyclic Deformation Behavior and Fatigue Crack Propagation of Low Carbon Steel Prestrained in Tension

Tailoring the Strength and Ductility of T91 Steel by Partial Tempering Treatment