Abstract:A multi-parametric transient numerical simulation of the start-up of a large diameter Pulsating Heat Pipe (PHP) specially designed for future experiments on the International Space Station (ISS) are compared to the results obtained during a parabolic flight campaign supported by the European Space Agency. Since the channel diameter is larger than the capillary limit in normal gravity, such a device behaves as a loop thermosyphon on ground and as a PHP in weightless conditions; therefore, the microgravity environment is mandatory for pulsating mode. Because of a short duration of microgravity during a parabolic flight, the data concerns only the transient start-up behavior of the device. One of the most comprehensive models in the literature, namely the in-house 1-D transient code CASCO (French acronym for Code Avanc{\'e} de Simulation du Caloduc Oscillant: Advanced PHP Simulation Code in English), has been configured in terms of geometry, topology, material properties and thermal boundary conditions to model the experimental device.The comparison between numerical and experimental results is performed simultaneously on the temporal evolution of multiple parameters: tube wall temperature, pressure and, wherever possible, velocity of liquid plugs, their length and temperature distribution within them. The simulation results agree with the experiment for different input powers. Temperatures are predicted with a maximum deviation of 7%. Pressure variation trend is qualitatively captured as well as the liquid plug velocity, length and temperature distribution. The model also shows the ability of capturing the instant when the fluid pressure begins to oscillate after the heat load is supplied, which is a fundamental information for the correct design of the engineering model that will be tested on the ISS. We also reveal the existence of strong liquid temperature gradients near the ends of liquid plugs both experimentally and by simulation. Finally, a theoretical prediction of the stable functioning of a large diameter PHP in microgravity is given. Results show that the system provided with an input power of 185W should be able to reach the steady state after 1min and maintain a stable operation from then on.

Electric Control System for Microgravity Fluid Experiment on SZ-4 Spaceship

Research on Melt Wettability Measurements under Microgravity

Research on the Performance of a Passive Gas-Liquid Separator Used in Space

Design and implementation of the highly-reliable, low-cost housekeeping system in the ZDPS-1A pico-satellite

Developing a Power Monitoring and Protection System for the Junction Boxes of an Experimental Seafloor Observatory Network.

Development and Experimental Study of Supercritical Flow Payload for Extravehicular Mounting on TZ-6

Development of a New Microgravity Experiment Facility with Electromagnetic Launch

Development and Space Experiment Verification of Annular Liquid Flow Payload for China Space Station

Development and Experiments of an Electrothermal Driven Deep-Sea Buoyancy Control Module

Groundbased Simulation of Flow,heat and Mass Transfer in Microgravity Environment

Design and Experimental Study of Space Manipulator Simulator System

Research on Segmented Power Supply Technology of Microgravity Experiment facility with Electromagnetic Launch

Research on Ground Microgravity Simulation System Based on Parallel Mechanism

Slow control system of the HIRFL-CSR External-target Experiment

Flight test results for microgravity active vibration isolation system on-board Chinese Space Station

Space Program SJ-10 of Microgravity Research

A Review on Simulated Micro-Gravity Experiment Systems of Space Robot

Ground Simulation of Flow and Heat Transfer under Micro-Gravity

Experimental analysis and transient numerical simulation of a large diameter pulsating heat pipe in microgravity conditions

Numerical study on electrohydrodynamic enhancement of PCM melting in cylindrical annulus under microgravity

Experimental Study on the Performance of an Aircraft Environmental Control System