Abstract:Boom Clay has been selected as a potential host rock formation for the geological disposal of radioactive waste in Belgium. In the present work, the hydro-mechanical behaviour of Boom Clay samples from the borehole Essen-1 at a depth of 220–260m and from HADES that is the underground rock laboratory at Mol in Belgium, at 223-m depth was investigated in the laboratory by performing low pressure oedometer tests (vertical effective stress ranging from 0.05 to 3.2MPa), high pressure oedometer tests (vertical effective stress ranging from 0.125 to 32MPa), isotropic consolidation tests (confining effective stress ranging from the in situ stress to 20MPa) and triaxial shear tests. It has been observed that the mineralogy, geotechnical properties and hydro-mechanical behaviour of Boom Clay from Essen at 227-m, 240-m and 248-m depths are similar to that of Boom Clay from Mol. As in the case of Boom Clay at Mol, the failure envelope of Boom Clay at Essen in the p′–q plane is not linear. The slope of the portion beyond the pre-consolidation stress of Boom Clay from Essen is almost the same as that from Mol, suggesting a similar internal friction angle of about 13°. The compression curves (void index Iv versus logarithm of vertical stress) beyond the pre-consolidation stress are the same for both samples from Mol and Essen, and situated between the intrinsic compression line (ICL) and the sedimentation compression line (SCL). The yield stress determined from oedometer tests seems to be stress-path dependent and lower than the pre-consolidation stress. Thus determining the over-consolidation ratio (OCR) using the yield stress value would lead to an incorrect estimate. From a practical point view, the laboratory test results from Essen and their comparison with those from Mol provide important information regarding the transferability of knowledge on Boom Clay at different sites, taking into account the fact that most investigations have been carried out on Boom Clay at Mol.

Stress and strain evolution of remoulded COx argillite during saturation

COMPRESSION BEHAVIORS OF CRUSHED COx ARGILLITE USED AS BACKFILLING MATERIAL IN HLW REPOSITORY

The Coupled Hydro-Mechanical Behaviours of Compacted Crushed Callovo-Oxfordian Argillite

Shrinkage Characteristics of Buffer-Backfilling Materials in High-Level Radioactive Waste Geological Disposal

Transversely Isotropic Poroelastic Behaviour of the Callovo-Oxfordian Claystone: A Set of Stress-Dependent Parameters

Investigating the microstructure of compacted crushed Callovo-Oxfordian argillite

Residual Lateral Stress Effect on the Swelling Pressure Measurements of Compacted Bentonite/claystone Mixture

@Modelling of failure and fracture development of the Callovo-Oxfordian claystone during an in-situ heating experiment associated with geological disposal of high-level radioactive waste

Investigating the swelling pressure of compacted crushed-Callovo-Oxfordian claystone

A laboratory investigation of thermally induced pore pressures in the Callovo-Oxfordian Claystone

Effect of Suction Changes on the Microstructure of Compacted Crushed Argillites under Constant-Volume Conditions

Effective stress incorporating osmotic suction and volume change behavior of compacted GMZ01 bentonite

An Experimental Study on the Secondary Deformation of Boom Clay

Thermo-poro-elastic behaviour of a transversely isotropic shale: Thermal expansion and pressurization

Swelling Deformation of Gaomiaozi Bentonite under Alkaline Chemical Conditions in a Repository

Investigation on Unsaturated Critical State and Hvorslev Surface of Compacted Bentonite under High Suction Conditions

Time-dependent permeability of fractured Callovo-Oxfordian claystone in laboratory and in situ drift excavation induced damaged zone in the claystone formation: experiment and numerical modeling

Inducing Tensile Failure of Claystone Through Thermal Pressurization in a Novel Triaxial Device

Mechanical Behavior of Claystone in Lateral Decompression Test and Thermal Effect

Insights into Anisotropic Swelling Pressure of Compacted GMZ Bentonite

Laboratory Hydro-Mechanical Characterisation of Boom Clay at Essen and Mol