Effect of Temperature on the Electrocatalytic Oxidation of Ethanol
Kunfang Tu,Guang Li,Yanxia Jiang
DOI: https://doi.org/10.3866/pku.whxb201906026
2020-01-01
Abstract:The electrocatalytic activity of commercial Pt/C for ethanol oxidation is relatively low, and the C-C bond is difficult to break. Thus, the complete oxidation process is not easy, and the fuel utilization efficiency becomes considerably reduced. Increasing the temperature can increase the reaction rate and enhance the mass transport; therefore, a temperature-controlled electrode was used during our in situ FTIRS (Fourier Transform Infrared Spectroscopy) investigation. The temperature sensor was placed at a certain distance from the surface of the electrode; thus, the surface temperature needed to be corrected. The temperature was calibrated using the "potentiometric" measurement method, which was because the potential-temperature coefficient of the redox couple is constant under certain conditions, and the electrode surface temperature was obtained by potential conversion at different temperatures during the experiment. The experimental results showed that the relationship between the heating temperature, T-h, and the surface temperature, T-S, was T-S = 0.57T(h) + 7.71 (30 degrees C < T-h <= 50 degrees C) and T-S = 0.62 T-h + 5.12 (50 degrees C < T-h <= 80 degrees C), and according to error analysis, the maximum error was 1 degrees C. The temperature-controlled electrode was applied to investigate the electrooxidation of ethanol using both in situ FTIRS and cyclic voltammetry using a commercial Pt/C catalyst at different temperatures. Clearly, based on the CV curve for the oxidation of ethanol, with increasing temperature, the overall oxidation current increased, and the onset potential and peak potential both negatively shifted, indicating that thermal activation allows the oxidation reaction to proceed easier. Electrooxidation of ethanol showed two positive oxidation peaks, and the ratio of the first peak current to the second peak current was used to qualitatively evaluate the selectivity of CO2. Compared with at 25 degrees C, the first peak current increased by 30% at 65 degrees C, indicating that the high temperature was conducive to C-C bond cleavage. Comparing the in situ FTIRS recorded at 50 degrees C, 35 degrees C, and 25 degrees C, we found that the onset potential of CO2 on the commercial Pt/C catalyst was lower by 200 mV, indicating that Pt/C can provide oxygen-containing species at lower potentials at high temperature; however, the onset potentials of CH3CHO and CH3COOH did not change with temperature. The CO2 selectivity was semi-quantitatively calculated by the area of CO2 compared with the area of CH3COOH from the FTIRS data. It was found that CO2 had the highest selectivity at high temperature and low potential, indicating that high temperature is conducive to complete ethanol oxidation during CO2 formation, possibly because both the ethanol bridge adsorption pattern and adsorbed OH (OHad) increased with temperature, enhancing subsequent COad and OHad oxidation reactions. The low selectivity of CO2 at the high potential was due to the adsorption of oxygen-containing species that occupied the surface-active site, blocking the adsorption of ethanol.