Abstract:⎯NaZr2 – xBx(PO4)3 – 2x(SO4)2x (0 ≤ x ≤ 1.25, B = Mg, Co, Ni, Cu, Zn), and NaZr2 – xRx(PO4)3 – x(SO4)x (0 ≤ x ≤ 1.25, R = Al, Fe) phosphate-sulfates series have been prepared by a sol–gel process. These compounds belong to the NaZr2(PO4)3 (NZP) structure family and crystallize in hexagonal crystal system, space group R c. Limited solid solution series were found to exist; their formation temperatures and thermal stability limits were determined. Particle sizes as determined by microstructure observation were 50–200 nm, and for Cuand Zn-containing samples, 200–500 nm. The thermal expansion of phosphate-sulfate NaZr1.25Cu0.75(PO4)1.5(SO4)1.5 was studied in the range 25–700°C. Thermal expansion coefficients and thermal expansion anisotropy were found to be αa = –5.40 × 10–6 °C–1, αс = 18.88 × 10–6 °C–1, αavg = 2.69 × 10–6 °C–1, and Δα = 24.28 × 10–6 °C–1. DOI: 10.1134/S0036023618060207 Design of heat-stress-resistant materials is an important and topical problem of modern materials science [1–5]. These materials can be used in the creation of products for nuclear and space technologies, ceramic pigments, in nuclear technologies for inert fuel matrices and matrices for disposal of radioactive waste, as well as for other applications. Their important properties are thermal stability over a wide temperature range, high thermal conductivity, and no deformation caused by thermal expansion that can lead to destruction. Of these materials, of interest are ceramics based on salt and oxide inorganic compounds. Particular attention should be paid to compounds crystallizing in the NaZr2(PO4)3 (NZP) structure type [6, 7]. These compounds are known for their high thermal stability [2, 8] and some of them for near-zero thermal expansion attained due to a specific heating behavior of the structure consisting in expansion–contraction in different crystallographic directions [3, 9–12]. Not only a low value of the thermal expansion coefficient is important for design of heat “stress” resistant materials, but also low thermal expansion anisotropy is. The structure of NaZr2(PO4)3 and compounds of its family is described by the general crystal-chemical formula (М1)VI(М2) [L (XO4)3], where L and М (М1 and М2) are framework atomic positions and interstitial (extraframework) positions, respectively; VI and VIII denote their coordination surroundings. Positions M can be occupied completely or partially, or they can remain vacant. They are populated mostly by low-charge and relatively large cations, while the [L (XO4)3] framework is built by multicharged cations of small size and negatively charged tetrahedral oxo anions XO4. Various isovalent and heterovalent substitutions, which are typical of the NZP structure [6, 7, 13, 14], create the possibility to tune the properties of compounds in the desired way, specifically thermal expansion characteristics. The thermal expansion model advanced in [6, 10] suggests that the heating behavior of such phosphates depends on the nature of the involved cations (their size, charge, and electronegativity), the major contributors being the weakest bonds. The cations in extraframework positions M and the occupancies of these positions have a greater influence. The following ways are known to reduce thermal expansion parameters in NZP compounds: (1) to increase the radius of an extraframework cation: here, the crystal-chemical principle runs ahead of the thermal one (the position is already expanded due to the residence of a large cation); (2) to reduce the M (interstitial) site occupancy: thereby, the number of cations responsible for thermal deformation is reduced; and (3) to generate solid solutions based on compounds of 3

A New Structure Type of Phosphate: Crystal Structure of Na2zn5(Po4)(4)

Poly[disodium Bis(μ-Malonato)zincate(ii) Dihydrate]

Synthesis and Structure of an Open-Framework Zincophosphate [C6n4h22][znpo4](4)

New Crystalline Layered Zinc Phosphate with 10-Membered-ring Channels Perpendicular to Layers.

Crystal Structures and Spectroscopic Properties of A New Zinc Phosphite Cluster and an Unexpected Chainlike Zinc Phosphate Obtained by Hydrothermal Reactions

Synthesis, Characterization and Crystal Structure Analysis of an Open-Framework Zirconium Phosphate

Zn-3(4-Oocc6h4po3)(2): A Polar Metal Phosphonate with Pillared Layered Structure Showing Shg-Activity and Large Dielectric Anisotropy

Ionothermal Synthesis, Structure and Characterization of Three-Dimensional Zinc Phosphates.

(NH4)3(H3O)Zn4(PO4)4: A nonlinear optical zinc orthophosphate crystal

Synthesis and characterization of a novel 1-D hybrid zinc phosphate (2,2 '-bipy)(2)Zn-2(PO4H)(PO4H2)(2)

The Synthesis and Characterization of a Two-Dimensional Cobalt−Zinc Phosphate: NH4[Zn2-xCox(PO4)(HPO4)] (x ≈ 0.12)

SYNTHESIS AND PROPERTIES OF INORGANIC COMPOUNDS New Phosphate-Sulfates with NZP Structure

Crystal Structure of Sodium Tetratin(Ii) Triphosphate, Nasn4(Po4)(3)

Synthesis, Crystal Structure and Optical Properties of a Novel Sodium Lead Pentaborate, NaPbB5O9

The crystal structure of poly[((2-(4,5-dihydro-1 H -pyrazol-4-yl)-1,3-dioxoisoindoline-5-carbonyl)oxy)(1-(dimethylamino)ethoxy)zinc[II]], C 16 H 14 ZnN 4 O 5

Crystal structure solution and high-temperature thermal expansion in NaZr2(PO4)3-type materials

Syntheses, structures and characterization of noncentrosymmetric MZnPO 4 (M = K, NH 4 )

Crystal chemistry and predicted ionic conductivity of hydrothermally synthesized Na 9 Zn 2 (PO 4 ) 4 Cl

A New Organo-templated Layered Zincophosphate Synthesized from a Solvothermal System Containing Racemic 1,2-Diaminopropane

Hydrothermal Synthesis and Crystal Structure of a New Sandwich-type Molybdenum Phosphate

Crystal Structure of New Zinc-Hydroxy-Sulfate-Hydrate Zn4(OH)6SO4·2–2.25H2O