Abstract:Direct writing utilizing a focused electron beam constitutes an interesting alternative to resist-based techniques, as it allows for precise and flexible growth onto any conductive substrate in a single-step process. One important challenge, however, is the identification of appropriate precursors which allow for deposition of the material of choice, e.g., for envisaged applications in nano-optics. In this regard the coinage metal silver is of particular interest since it shows a relatively high plasma frequency and, thus, excellent plasmonic properties in the visible range. By utilizing the precursor compound AgO2Me2Bu, direct writing of silver-based nanostructures via local electron beam induced deposition could be realized for the first time. Interestingly, the silver deposition was strongly dependent on electron dose; at low doses of 30 nC/μm2 a dominant formation of pure silver crystals was observed, while at higher electron doses around 104 nC/μm2 large carbon contents were measured. A scheme for the enhanced silver deposition under low electron fluxes by an electronic activation of precursor dissociation below thermal CVD temperature is proposed and validated using material characterization techniques. Finally, the knowledge gained was employed to fabricate well-defined two-dimensional deposits with maximized silver content approaching 75 at. %, which was achieved by proper adjustment of the deposition parameters. The corresponding deposits consist of plasmonically active silver crystallites and demonstrate a pronounced Raman signal enhancement of the carbonaceous matrix.

NANO-STRUCTURED SILVER COATING ON COPPER PREPARED IN AN ETHANOL-BASED SOLUTION

On the Microstructure of Immersion Silver on Sputtered Copper

Electrochemical synthesis of silver oxide nanowires, microplatelets and application as SERS substrate precursors

Deposition Process of Immersion Silver Plating Onto Copper Substrate in Silver Nitrate Aqueous Solution

Nanoscale characterization of thin immersion silver coatings on copper substrates

Electroless Copper Plating Onto Printed Lines of Nanosized Silver Seeds

Study on Non-Cyanide Silver Electroplating with Copper Substrate

Environmental Friendly Silver Brush-Plating Technique and Its Application

Synthesis of Silver Particles on Copper Substrates Using Ethanol-Based Solution for Surface-Enhanced Raman Spectroscopy

Fabrication and Wettability of Nanoporous Silver Film on Copper from Choline Chloride-Based Deep Eutectic Solvents

Deposition and wettability of silver nanostructures on Si(1 0 0) substrate based on galvanic displacement reactions

Focused electron beam induced deposition of copper with high resolution and purity from aqueous solutions

Silver dendritic nanostructures formed at the solid/liquid interface via electroless deposition

Cyanide-free Silver Immersion Deposition Involving 3-Mercapto-1-propanesulfonic Acid for Copper Finishing

Study of Preparation on the Flake Silver Coating over Copper Powder for Electronic Industry

Fabrication and performance of silver coated copper powder

Preparation of silver-coated copper powder and its oxidation resistance research

Direct Electron Beam Writing of Silver-Based Nanostructures

Surface-Enhanced Raman Scattering of Silver@Nanoporous Copper Core−Shell Composites Synthesized by an In Situ Sacrificial Template Approach

Complexing Agent Study Via Computational Chemistry for Environmentally Friendly Silver Electrodeposition and the Application of a Silver Deposit

Preparation of Silver Nanosheets Used for Low Temperature Bonding