Abstract:Heat treatments are used when sintering hydroxyapatite to make porous blocks and granules and during plasma spraying of coatings. Calcium : phosphorus ratio is known to affect the thermal decomposition behavior of hydroxyapatite. Hydroxyapatite with carbonate ions substituted for phosphate ions is more similar in composition to bone mineral. While it has been shown that carbonate apatite may be sintered, relatively little is known about its high temperature stability. Various atmospheres have been used in investigations into the thermal stability of hydroxyapatites and carbonate hydroxyapatites, including nitrogen, wet carbon dioxide air, water vapor and wet oxygen, but few of these studies were directly comparable. Previous work has shown that loss of carbonate from CHA at high temperature is time dependent, which suggests that rapid high temperature treatment may prevent carbonate loss during processing. This study investigated the effect of dry carbon dioxide, carbon dioxide containing 3% water, nitrogen and nitrogen containing 3% water on the phase composition of hydroxyapatite containing between 1.0 and 11.5 wt % carbonate rapidly heated to temperatures of between 700 and 1400 degrees C. Carbonate ion substitution was observed to decrease the temperature at which crystallisation occurred to a minimum of 700 degrees C for 11.8 wt % carbonate apatite heated in wet atmospheres. Atmosphere was found to appreciably affect the crystallization temperature and phase transformations of carbonate apatite containing 7.8 wt % carbonate. In wet and dry carbon dioxide atmospheres, crystallisation began in this material at 1100 and 900 degrees C, betaTCP was formed at 1500 and 1300 degrees C respectively. The high temperature decomposition of carbonate hydroxyapatite would appear to depend on the composition of the apatite and the atmosphere in which it is heated.

Structure of Carbonated Hydroxyapatite Based on Rietveld Method

Effect of sintering temperature on the morphology, crystallinity and mechanical properties of carbonated hydroxyapatite (CHA)

Hydrothermal synthesis of nano-hydroxyapatite crystals

Investigation on Heat Treatment of Carbonated Hydroxyapatite

EFFECT OF INITIAL CARBONATE CONTENT AND HEAT TREATMENTS ON PREPARATION AND PROPERTIES OF CARBONATED HYDROXYAPATITE

Evaluation of Nanostructured Carbonated Hydroxyapatite Coatings Formed by a Hybrid Process of Plasma Spraying and Hydrothermal Synthesis

Thermal Stability of Porous A-type Carbonated Hydroxyapatite Spheres

FTIR, XRD, SEM and solid state NMR investigations of carbonate-containing hydroxyapatite nano-particles synthesized by hydroxide-gel technique

EFFECTIVE FACTORS OF PREPARATION FOR CARBONATED HYDROXYAPATITE BY THE AQUEOUS PRECIPITATION METHOD

Ab Initio Simulation on the Crystal Structure and Elastic Properties of Carbonated Apatite

Thermal decomposition of synthesised carbonate hydroxyapatite

Thermal stability of stoichiometric strontium-incorporated hydroxyapatite

Thermal Stability of Nonstoichiometric Stronium-Incorporated Hydroxyapatite Synthesized with A Hydration Process

Wet synthesis and structure stability of strontium-containing hydroxyapatite

Effect of process conditions on morphologies of nano-hydroxyapatite

Citrate-Assisted One-Pot Hydrothermal Preparation of Carbonated Hydroxyapatite Microspheres

Influences of Sr dose on the crystal structure parameters and Sr distributions of Sr-incorporated hydroxyapatite

Effects of Strontium Substitution on the Structural Distortion of Hydroxyapatite by Rietveld Refinement and Raman Spectroscopy

Rerystallization And Structure Of Plasma Sprayed Hydroxyapatite Coating

Investigation of EDTA concentration on the size of carbonated flowerlike hydroxyapatite microspheres

Study on Physicochemical Properties of the Carbonated Hydroxyapatite Bone Cement