Abstract:With the improvement of voltage levels,radio interference caused by transmission line has attracted much attention.Test line can be directly used to study the transmission line radio interference characteristics,which provides a reliable basis for engineering design,and it has been more widely used at home and abroad.Which is different from actual transmission line at the connecting ends,test line radio interference current produced by corona will reflect at the end,and measurement results can＇t be directly applied to practical circuit.So we need to study the radio spectrum relationship between short and long lines,to ensure that test results and data analysis method is reliable.The model in this paper is based on the radio interference current spread mechanism,and the simulation results show the effectiveness of radio interference measurement on test line.It also gives the methods of measurement and data analysis of the radio interference on test line,the equivalent of different terminals（open circuit,short circuit,capacitors） and the impact of measuring points.These methods can be used to measure radio interference currents and space radio interference.The averaged envelope of spectrum on the short-term maximum and minimum values is the actual transmission line radio interference spectrum with same corona current circumstances.

Analysis and Study on the Noise in Simulations of Communication Systems

Practical study on teaching of communication principle based on SystemView

Analysis on Anti-Noise Performance of Frequency Modulation System Based on MATLAB Simulation

Design and Analysis of Models of Digital Baseband Transfer System Based on SystemView

Design and Analysis of model of the Narrow Band Frequency Modulation Based on SystemView

Performance of A Multi-Port Multi-Channel RF-Interconnect Model

The Implementation of Minimal Noise Figure Receiver

Analyses of Noncommensurate Sampling Used in High-Precision Regenerative Pseudo-Noise Ranging Systems

MEASUREMENT AND ANALYSIS OF HIGH FREQUENCY NOISES ON LOW-VOLTAGE POWER NETWORKS

Modeling the simultaneous switching noise with the integral equation method and vector fitting method

Modeling of the Simultaneous Switching Noise in High Speed Electronic Circuit with the Integral Equation Method and Vector Fitting Method

Miniature Optical Signal Transmission System for PDN Noise Measurement

Numerical simulation of the impact of atmospheric turbulence on the laser signal

Noise performance analysis of PT-symmetric non-reciprocal transmission systems

Simulation for Transmission Attentuation over Low Voltage Distribution Networks

THE VARIABLE-DURATION IMPULSIVE NOISE MODELING IN IEEE 802.15.4-2020 STANDARD RADIO COMMUNICATION SYSTEMS

Simulation Analysis of Effectiveness of Radio Interference Measurement on Test Line

Research on Anti-noise Properties of Coding Channel in the Impulse Noise Environment

The Analysis and Disposal of Imaging Circuit Noise Effect on Star Sensor

Noise Figure in UWB Systems

Communications under Bursty Mixed Gaussian-impulsive Noise: Demodulation and Performance Analysis