Abstract:The understanding of the lateral morphology stability of thin polymer devices is of fundamental importance. In this work, the lateral morphology in a model system consisting of thin polymer films capped with thin metal layers on a Si substrate is investigated. When the model system is heated above a critical temperature, a characteristic surface topographic structure is observed that has a well-defined periodicity but random orientation. It is shown that the minimum temperature, T-min, required for the surface pattern to be observed decreases with increasing polymer-film thickness. Increasing either the metal- or polymer-layer thickness increases the characteristic wavelength of the topography. It is believed that the dominating driving force for the surface corrugated-pattern formation is the thermal-expansion-coefficient mismatch of the capping layer and the substrate. A theoretical model based on local bending of a thin, stiff surface film on a thin, elastic medium is used to provide a quantitative analysis of the surface morphology. The calculated minimum temperature required for the surface morphology and the periodicity of the surface patterns to form are in strong agreement with the experimental results. By contrast, systems with prefabricated topographic patterns within any of the three layers (polymer, metal, substrate) produce highly anisotropic surface topographies aligned perpendicular to the prefabricated topographic structure. It is also found that, in a model system with pre-patterned polymer films, a much higher critical temperature is required for the surface morphology to be observed. The changes in apparent stability and morphological orientation in the pre-patterned systems can be understood as a result of the anisotropic release of the lateral surface stress during the heat treatment.

Pattern Formation in a Confined Polymer Film Induced by a Temperature Gradient

Temperature controlled lateral pattern formation in confined polymer thin films

Mechanisms of Ordering in Striped Patterns

Hierarchical Polymer Patterns Driven by Capillary Instabilities at Mobile and Corrugated Polymer–polymer Interfaces

Microdomain Morphology of Lamella‐forming Diblock Copolymer Confined in a Thin Film

Spontaneous Formation of Ordered Lateral Patterns in Polymer Thin‐Film Structures

Pattern Formation by Dewetting of Polymer Thin Film

Large Area Ordered Lateral Patterns in Confined Polymer Thin Films

Pattern formation in polymer films under the mask

Vertical pattern decay and lateral in-phase capillary breakup of nanoimprinted bilayer polymer films

Phase Separation Induced Ordered Patterns in Thin Polymer Blend Films

Pattern Formation in Thin Polymeric Films Via Electrohydrodynamic Patterning

Pattern formation in thin polymeric films <i>via</i> electrohydrodynamic patterning

Controlled Formation of Surface Patterns in Metal Films Deposited on Elasticity-Gradient PDMS Substrates.

Stability And Surface Topography Evolution In Nanoimprinted Polymer Patterns Under A Thermal Gradient

Room-Temperature Electrically Induced Micro-Structure Patterning Mechanism and Technique

Spontaneous formation of ordered structures in thin films of metals supported on an elastomeric polymer

Phase Dynamics and Wetting Layer Formation Mechanisms of Pattern-Directed Phase Separation in Binary Polymer Mixture Films with Asymmetry Compositions

Patternation of Polymer Structures by Guided Anisotropic Dewetting

Confinement-Induced Ordering in Dewetting and Phase Separation of Polymer Blend Films

Formation of Ordered Two‐Dimensional Polymer Latticeworks with Polygonal Meshes by Self‐Organized Anisotropic Mass Transfer