Abstract:Introduction. The control algorithm of Induction Motor (IM) is massively dependent on its parameters; so, any variation in these parameters (especially in rotor resistance) gives unavoidably error propagates. To avoid this problem, researches give more than solution, they have proposed Variable Structure Control (VSC), adaptive observers such as Model Reference Adaptive System, Extended Luenberger Observer (ELO) and the Extended Kalman Filter (EKF), these solutions reduce the estimated errors in flux and speed. As novelty in this paper, the model speed observer uses the estimated currents and voltages as state variables; we develop this one by an error feedback corrector. The Indirect Rotor Field Oriented Control (IRFOC) uses the correct observed value of speed; in our research, we improve the observer’s labour by using back-stepping Sliding Mode (SM) control. Purpose. To generate the pulse-width modulation inverter pulses which reduce the error due of parameters variations in very fast way. Methods. We develop for reach this goal an exploration of two different linear observers used for a high performance VSC IM drive that is robust against speed and load torque variations. Firstly, we present a three levels inverter chosen to supply the IM; we present its modelling and method of control, ending by an experiment platform to show its output signal. A block diagram of IRFOC was presented; we analyse with mathematic equations the deferent stages of modelling, showed clearly the decoupling theory and the sensorless technique of control. The study described two kinds of observers, ELO and EKF, to estimate IM speed and torque. By the next of that, we optimize the step response using the fuzzy logic, which helps the system to generate the PI controller gains. Both of the two observers are forward by SM current controller, the convergence of SM-ELO and SM-EKF structures is guaranteed by minimizing the error between actual and observed currents to zero. Results. Several results are given to show the effectiveness of proposed schemes.

Sensorless Vector Control System of Induction Motor Fed by Three-Level Inverter Using a Full Order Observer

An Adaptive Observer Design for Sensorless Control of Induction Motors

Speed Sensorless Vector Control Based on Full-order Adaptive Observer for Induction Motor Drives at Low Speed

Speed-sensorless Direct Torque Control System of Induction Motor

Speed Sensorless Vector Control of Induction Motor Based on Full-Order Flux Observer

Extremely Low Speed Performance Research of the Speed Sensorless Vector Controlled Induction Motor Drive System

Speed Sensorless Fuzzy Vector Control of Induction Motor Using an Adaptive Observer

Speed sensorless control for three-level inverter-fed induction motors using an Extended Luenberger Observer

Sensorless control and start-up strategy of permanent magnet synchronous motor

Sensorless 3-level inverter-fed induction motor drive based on indirect torque control

Speed Sensorless Vector Control with Improved Closed-Loop Flux Observer for Induction Machines

Sensorless Vector Control of Multiphase Induction Machine Based on Full-Order Observer and Harmonic Suppression

Sensorless Control with Resistance Variation Approach Based on Parallel MRAS and Second-Order Sliding Mode Observer

Study of Adaptive Flux Observer and Speed Identification Method for Induction Motor

Adaptive Speed Observer for Speed Sensorless Control of Induction Motor

Intelligent fuzzy back-stepping observer design based induction motor robust nonlinear sensorless control

Nonlinear Flux Observer for Sensorless Control of IPMSM Based on a Novel Regression Model

A three-level speed sensor-less DTC drive of induction motor based on a full-order flux observer

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

Full-order Flux Observer Based on Speed and Stator Resistance Adaptation for Induction Motor

Sensorless Robust Predictive Current Control For Induction Motor Using A Speed Adaptive Full-Order Observer