Abstract:This work explored and contrasted the effect of microstructure on the tensile properties of AlSi10Mg alloys generated by transient directional solidification depending on variations in cooling rate and magnesium (Mg) content (i.e., 0.45 and 1 wt.% Mg), with a focus on understanding the dendritic growth and phases constitution. Optical and scanning electron (SEM) microscopies, CALPHAD, and thermal analysis were used to describe the microstructure, forming phases, and resulting tensile properties. The findings showed that the experimental evolution of the primary dendritic spacing is very similar when both directionally solidified (DS) Al-10 wt.% Si-0.45 wt.% Mg and Al-10 wt.% Si-1 wt.% Mg alloys samples are compared. The secondary dendritic spacing was lower for the alloy with more Mg, especially considering the range of high growth velocities. Moreover, a greater fraction of (Al + Si + Mg2Si) ternary eutectic islands surrounding the α-Al dendritic matrix was noted for the alloy with 1 wt.% Mg. As a result of primary dendritic spacings greater than 180 μm related to lower cooling rates, slightly higher tensile properties were attained for the Al-10 wt.% Si-0.45 wt.% Mg alloy. In contrast, combining dendritic refining (<150 μm) and a larger Mg2Si fraction, fast-solidified DS Al-10 wt.% Si-1 wt.% Mg samples exhibited higher tensile strength and elongation. The control of cooling rate and fineness of the dendritic array provided a new insight related to the addition of Mg in slightly higher levels than conventional ones, capable of achieving a better balance of tensile properties in AlSi10Mg alloys.

Relationship Between Liquid Structure and Property Ⅱ—— Kinematic Viscosity of Mg-9Al Melt and Its Relationship with the Microstructure

Relationship Between Liquid Structure and Property Ⅰ- Kinematic Viscosity of Magnesium Melt and Its Relationship with the Microstructure

Micro-Mechanism For The Evolution Of Viscosity Versus Temperature In Magnesium-Aluminum Alloy Melts

Structure and Property of Metal Melt III—Relationship Between Kinematic Viscosity and Size of Atomic Clusters

Microstructure Evolution and Properties of Mg-9Gd-0.8Al Alloy with Lamellar Phase During Extrusion at Different Temperatures

Relationship Between Liquid Structure and Property Iii-Residual Bond Theoretical Model

Atomic Structure, Diffusivity and Viscosity of Al1-xMgx Melts from Ab Initio Molecular Dynamics Simulations

Exploration of the Viscosity Temperature Dependences and Microstructure of Magnesium-Based Commercial Alloy AZ91D with Small Additions of Calcium

EET Research on Melt Structural Information of Magnesium Alloy

A theoretical method to calculate the viscosity of NaAlSi 3O 8 melt

Relationship Between Structure and Viscosity of CaO–SiO2–MgO–30.00 Wt-%Al2o3 Slag by Molecular Dynamics Simulation with FT-IR and Raman Spectroscopy

Relationship between Microstructure Evolution and Tensile Properties of AlSi10Mg Alloys with Varying Mg Content and Solidification Cooling Rates

Structure and property of metal melt IV—Evolution of titanium melt residual bond structure and its effect on dynamic viscosity

Viscosity of Al-Ni-Co-Nd(Sm) glass-forming melts at high temperatures

Understanding the Relationship Between Structure and Thermophysical Properties of CaO-SiO 2 -Mgo-al 2 O 3 Molten Slags

Investigation of viscosity measurements of molten Cu-Zr-Al alloys

Structure and Property of Metal Melt Ii-Evolution of Atomic Clusters in the Not High Temperature Range above Liquidus

Relationship Between Structure and Viscosity of CaO–SiO2–Al2O3–MgO–TiO2 Slag

Microstructural transformations of two representative slags at high temperatures and effects on the viscosity

Viscosity of AZ91D Magnesium Alloy Melt with Small Additions of Calcium

Study of the Effect of the MgO/Al2O3ratio on Viscosity of Blast Furnace Slag