Effects of Fuel Sulfur Content and Diesel Oxidation Catalyst on Pm Emitted from Light-Duty Diesel Engine
Hong Zhao,Yunshan Ge,Xiaochen Wang,Jianwei Tan,Aijuan Wang,Kewei You
DOI: https://doi.org/10.1021/ef900982c
IF: 4.6541
2010-01-01
Energy & Fuels
Abstract:The effects of fuel sulfur content and diesel oxidation catalyst on number-size distribution, sulfate, and trace metals of particulate matter (PM) emitted from a Euro 3 light-duty diesel engine have been investigated. Three types of diesel fuel with sulfur content of 1000 ppm, 350 ppm and 19 ppm respectively were used in this study. According to the results, the number concentration of nanoparticles for low sulfur fuel compared to other two fuels decreased, but accumulation and coarse mode particles increased. With the use of DOC, the number concentration of different size range reduced at 50% load; while at full load, the reduction efficiency was 20-80% for 19 pp, sulfur fuel, and 30-50% only for nanoparticles for other two fuels. The results revealed that the presence of the catalyst and variations in fueld sulfur content altered the extent to which hydrocarbons and sulfates condense on the soot particles and the exhaust sampling methodology promoted the additional coagulation. Both sulfate emission rate and fuel consumption increased with sulfur content. Higher fuel consumption at higher load increased the concentration of SO2 and thus resulted in the generation of large concentration of sulfate. At low load, sulfate to PM mass ratio with DOC was less than that of without DOC; whereas at medium and high loads, the results were contrary. At medium and high loads, catalyst temperature was higher,, which converted SO2 into SO3 effectively, and thus generated sulfate. The emission rates of Na, Ca, Mg, K, Al, Ni, and Cr for higher fuel were more than those for lower sulfur fuel. After engine was retrofitted with DOC, Na, K, and Fe emission increased regardless of load. The emission of Mg, Zn, Cu, and Ca were affected by DOC, as well as by load level.