Abstract:Among the recently discovered Fe-based superconducting compounds, the (K,Ba)Fe2As2 phase is attracting large interest within the scientific community interested in conductor developments. In fact, after some years of development, critical current densities Jc of about 105 A/cm2 at fields up to more than 10 T have been obtained in powder in tube (PIT) processed wires and tapes. Here we explore the crucial points in the wire/tape fabrication by means of the ex-situ PIT method. We focus on scaling up processes which are crucial for the industrial fabrication. We analyzed the effects on the microstructure of the different heat and mechanical treatments. By an extensive microstructural analysis correlated with the transport properties we addressed the issues concerning the phase purity, the internal porosity and crack formation in the superconducting core region. Our best conductors with a filling factor of about 30 heat treated at 800 C exhibited Tc = 38 K the highest value measured in such kind of superconducting tape. The microstructure analysis shows clean and well connected grain boundaries but rather poor density: The measured Jc of about 3 x 10^4 A/cm2 in self-field is suppressed by less than a factor 7 at 7 T. Such not yet optimized Jc values can be accounted for by the reduced density while the moderate in-field suppression and a rather high n-factor confirm the high homogeneity and uniformity of these tapes.

Research and Progress in MgB2 Superconducting Tapes and Wires

Fabrication and Superconducting Properties of MgB2 Wires with Amorphous Carbon Doping by In-situ Powder-in-tube Method

Influence of the Preparation Process on Microstructure, Critical Current Density and Tc of MgB2 Powder-In-Tube Wires

Fabrication and Properties of Multifilamentary MgB2 Wires by In-Situ Powder-in-tube Process

FABRICATION AND CHARACTERIZATION OF MgB_2/Fe BY EX-SITU PIT METHOD

High-energy ball milling and synthesi temperature study to improve superconducting properties of MgB2 ex-situ tapes and wires

Preparation and Superconductivity of a MgB2 Superconducting Tape

Properties of superconducting MgB_2 wires: "in-situ" versus "ex-situ" reaction technique

Development of Powder-in-Tube Processed Iron Pnictide Wires and Tapes

Superconducting properties of the powder-in-tube Cu-Mg-B and Ag-Mg-B wires

High transport critical current density obtained for Powder-In-Tube-processed MgB2 tapes and wires using stainless steel and Cu-Ni tubes

Possibilities of MgB2/Cu Wires Fabricated by the in-situ Reaction Technique

Development of high-performance iron-based superconducting wires and tapes

Improving superconducting properties of 100 m class MgB 2 wire with 18+1 filaments produced via internal Mg diffusion process

Effect of Nano-C Doping on Thein-Situprocessed MgB2tapes

Fabrication and Superconducting Properties of Nano-Sic Doped MgB 2 Tapes

Influence of Preparation Process on Microstructure, Critical Current Density and Tc of MgB2/Fe/Cu Wires

The Preparation of MgB 2 Conductors for Magnet Application of SMES in WST

Role of heat and mechanical treatments in the fabrication of superconducting Ba0.6K0.4Fe2As2 ex-situ Powder-In-Tube tapes

Investigation of Layered Structure Formation in MgB2 Wires Produced by the Internal Mg Coating Process under Low and High Isostatic Pressures

Large transport critical currents in unsintered MgB2 superconducting tapes