Abstract:Electrochemical electric double layer capacitors (EDLC) known as supercapacitors are used for high power density, long cycle life and good reversibility of charge/discharge processes[1]. Recent years, many Schiff base transition metal composites acting as an electroactive electrode material deposited on carbon nanotubes(CNTs) have been researched[2]. However, the CNTs tend to be random orientation, twining round and cross linked. So it urgently need to be addressed. In this paper, a given mass of NH4BF4 was added to CNTs and the electrode was prepared by the homodispersion of the raw support material in N-methyl- 2-pyrrolidone (NMP) through sonicating. The slurry was coated on a Ti sheet with the coating mass of 0.3 mg. The electropolymerization of Ni(salen) on the resulting electrode was conducted in a closed three-electrode compartment cell adopted chronoamperometry method. The introduction of NH4BF4 to the CNTs with a specific percentage (5wt. %, 10wt. %, 15 wt. %), and the modified samples were named as NBF5, NBF10, NBF15 respectively and the CNTs without NH4BF4 were taken as a control group and named as NBF0. As the cyclic voltammetric data summarized in Table 1, the values of apparent surface coverage(Γ) and doping level(n) of NBF5, NBF10 and NBF15 didn't appear to be much different from those of NBF0. However, the specific capacitance varied a lot. It can be seen that Cm of NBF15 is the most among the samples. Figure 1 depicts the GCD plots of the composite and CNTs at the current density of 1.0 mA cm-2. CNTs have symmetric change in the charge/discharge process which is the characteristic of high Coulombic efficiency. It is clear that the composites possess longer charge/discharge time than CNTs which indicating that poly[Ni(salen)] contributes the pseudo-capacitance derived from reversible redox switching between neutral and oxidative states on the basis of electric double-layer capacitance of MWCNTs. Because of the introduction of NBF, it became difficult for CNTs to twint together disorderly. And the morphylogy of the electrode support got homogeneous. NBF-containing carbon nanotube could provide basic sites, and consequently improved the deposition of polymer and enhance the performance of the electrode material. Acknowledgement This work is financially supported by the National Natural Science Foundation of China (No. 51372021). References [1] D. Kaufman, K.L. Hudson, R. Mcclamrock. Science. 343 (2014) 1210–1211. [2] Y. Zhang, J. Li, F. Gao, F. Kang, X. Wang, F. Ye, J. Yang. Electrochim. Acta. 76 (2012) 1–7. Figure 1

Oxidation Behavior of CNTs and the Electric Double Layer Capacitor Made of the CNT Electrodes

Oxidation of Multiwalled Carbon Nanotubes by Air: Benefits for Electric Double Layer Capacitors

Controlled electrochemical oxidation for enhancing the capacitance of carbon nanotube composites

A Study of Activated Carbon Nanotubes As Double-Layer Capacitors Electrode Materials

Processing And Performance Of Electric Double-Layer Capacitors With Block-Type Carbon Nanotube Electrodes

Electrochemical Double-Layer Capacitors Based on Activated Bamboo-Shaped Carbon Nanotubes

Effect of Extremely Short-Sized MWCNT as Additive Material in High Surface Area Activated Carbon and Its Enhanced Electrical LIC Performance

Surface Oxidation Modification and Performance of Activated Carbon Electrode Material

Exploration of Charge Storage Behavior of Binder-Free EDL Capacitors in Aqueous Electrolytes

Effects of Ball Milling on Electrochemical Capacitances of Multiwalled Carbon Nanotube Bundles

CO2 Oxidation of Carbon Nanotubes for Lithium-Sulfur Batteries with Improved Electrochemical Performance

Electrochemical Introduction of Active Sites into Super-long Carbon Nanotubes for Enhanced Capacitance

Novel carbon materials for electrochemical double layer capacitors and their applications

Gas-liquid detonation synthesis of CNTs@Fe/Fe3C composites and their application as electrode materials for double-layer capacitors

The Electrochemical Performance of Nitrogen-Containing Carbon Nanotubes As the Electrode Material of Supercapacitors

Cooperation of micro- and meso-porous carbon electrode materials in electric double-layer capacitors

Integrated Carbon Nanotube and Ketoenamine‐Linked Covalent Organic Framework with Positive Charge Structure as High‐Performance Capacitive Materials

Surface Modification Effect and Electrochemical Performance of LiOH-High Surface Activated Carbon as a Cathode Material in EDLC

A Facile Approach to Improve Electrochemical Capacitance of Carbons by in Situ Electrochemical Oxidation.

How Carboxylic Groups Improve the Performance of Single-Walled Carbon Nanotube Electrochemical Capacitors?

IntegratingCarbon Dots with Porous Hydrogels to ProduceFull Carbon Electrodes for Electric Double-Layer Capacitors