Abstract:Currently, there is an increase in the production of carbon nanomaterials in the world, which is associated with their unique physical and mechanical properties and their use in various fields of science, industry and technology. Investigation of the chemical composition of waste gases from a propane-butane mixture pyrolysis unit during the synthesis of carbon nanomaterials is of scientific and applied value, since it allows one to study both the chemistry of the pyrolysis process of hydrocarbon mixtures and determine the degree of toxicity of waste gas from pyrolysis units. The quantitative determination of polycyclic aromatic hydrocarbons in the gaseous products of pyrolysis of a propane-butane mixture during the synthesis of carbon nanomaterials has shown that when sampling with a small amount of the Supelpak-2 adsorbent, which is widely used in international and domestic methods, efficient capture of multinuclear aromatic hydrocarbons is not ensured. Therefore, an important research issue is the development of a simple and effective method for sampling polycyclic aromatic hydrocarbons with their subsequent GC-MS analysis. The principal essence of the technique is the impregnation of two fiberglass filters with an organic low-volatile solvent – diethylene glycol, tetraethylene glycol or dimethyl sulfoxide. The latter is characterised by the highest extracting power in relation to polycyclic aromatic hydrocarbons. The developed technique makes it possible to increase the efficiency of capturing multinuclear aromatic hydrocarbons (with four or more rings in a molecule) to 96–98 % compared to a solid adsorbent under equal conditions (pyrolysis conditions, weight of adsorbent equal with filters impregnated with a solvent), where the degree of their extraction is 1–5 %. The established values of the degree of recovery of the measured components are explained by the high extracting ability of dimethyl sulfoxide in relation to multinuclear aromatic hydrocarbons.

Determination of naphthalene in scrap desulfurizer by solid phase microextraction and GC/MS

Determination of Nonylphenol in Textile Auxiliaries by Solid Phase Extraction-Gc-ms-sim

Determination of Nonylphenols in Domestic Sewerage by Solid Phase Microextraction and Gas Chromatography

Analysis of trace-level nitrated polycyclic aromatic hydrocarbons in water samples by solid-phase microextraction with GC-MS.

Determination Of 67 Volatile Organic Compounds In Ambient Air Using Thermal Desorption-Gas Chromatography-Mass Spectrometry

Determination of Sulphur in SCR Denitrification Catalyst by High Frequency Combustion Infrared Absorption Method

Solid-phase Microextraction Combined with Gas Chromatography/triple Quadrupole Tandem Mass Spectrometry for Determination of Nitrated Polycyclic Aromatic Hydrocarbons in Sediments

Adsorption and desorption of gaseous naphthalene on carbonaceous sorbents: Insights into advantageous pore sizes and morphologies

Determination of Nitrobenzenes in Air by a Needle Trap Device (NTD) and Gas Chromatography-Mass Spectrometry (GC-MS)

Solid-Phase Room-Temperature Fluorescence Using a Nylon Membrane for the Determination of 2-Naphthalene Sulfonic Acid

Determination of N-alkanes in Atmospheric Fine Particulate Matter by Gas Chromatography Mass Spectrometry with Ultrasonic Extraction

Quantification of nitrated-polycyclic aromatic hydrocarbons in atmospheric aerosol samples with in-injection port thermal desorption-gas chromatography/ negative chemical ionization mass spectrometry method

Determination of Organic Pollutants in Coking Wastewater by Dispersive Liquid-Liquid Microextraction/gc/ms.

Determination of N-Alkanes Contamination in Soil Samples by Micro Gas Chromatography Functionalized by Multi-Walled Carbon Nanotubes

Sampling and concentration of polycyclic aromatic hydrocarbons from exhaust gases from a plant for synthesis of carbon nanomaterials

Deep Desulfurization Performance of Thiophene with Deep Eutectic Solvents Loaded Carbon Nanotube Composites

Solid-Phase Extraction Of Tobacco-Specific N-Nitrosamines With A Mixed-Mode Hydrophobic/Cation-Exchange Sorbent

A solid-phase microextraction fiber with carbon nanoparticles as sorbent material prepared by a simple flame-based preparation process

Determination of Endosulfan Residues in Exporting Eel by Gas Chromatography and Verified by Gas Chromatography-Mass Spectrometry

Research on Adsorption and Desorption Performance of Gas-Phase Naphthalene on Hydrophobic Modified FDU-15

Application of Near Infrared Spectroscopy Coupled with Fluidized Bed Enrichment and Chemometrics to Detect Low Concentration of Β-Naphthalenesulfonic Acid