Abstract:As an important energy conversion component in electromagnetic-forming technology, the coil is subjected to great internal stress and is easy to break. The geometric structure and winding process of the forming coil draw on the research results of pulsed magnets. However, the two use conditions are different. It is very important to clarify the force difference between the two for the design of the forming coil. In this paper, the numerical model of an aluminum alloy (AA1060-O) is established, and the difference in force between the pulse magnet and forming coil with the same size in time and space under different working conditions is analyzed. A two-dimensional fully coupled finite element model consisting of circuit, magnetic field, and solid mechanics is established and used to determine the key parts of the coil force. It is found that the von Mises stress of the forming coil is greater than that of the pulsed magnet under the same circuit parameters and geometric structure. In the electromagnetic forming of the tube, the glass fiber is subjected to a large stress. In addition, the stress of glass fiber under the condition of tube necking is about 2 times that of pulsed magnet. When the voltage is increased, the failure of the middle part of the glass fiber causes the coil to break. In the electromagnetic forming of the sheet, the coil skeleton is subjected to large stress, and its upper end failure causes the coil to break. Therefore, new design ideas for forming coils under different working conditions are proposed.

Research on Magnetic Pulse Sizing of Aluminum Tube

Magnet circuit design and optimization of giant magnetostrictive transducer

Numerical simulation and experimental study on axial compression electromagnetic bulging of aluminum alloy tube

Effect of pulse width of middle-coil current on deformation behavior in electromagnetic tube forming under two-stage coils system

The Numerical Analysis of Force and Comparison of Pulse Magnet and Electromagnetic Forming Coil

EXPERIMENTAL RESEARCH ON MAGNETIC PULSE JOINING OF 3A21 ALUMINUM ALLOY-20 STEEL TUBES

Magnetic pulse welding of aluminum to steel tubes using a field-shaper with multiple seams

Effects of ring groove and gap on tensile strength of magnetic pulse joint of AA5052-steel 20 tubes

Tendency of Homogeneous Radial Deformation During Electromagnetic Compression of Aluminium Tube

Magnetic pressure in electromagnetic aluminum tube-compression forming

Experimental Investigation on Fabrication of Al/Fe Bi-Metal Tubes by the Magnetic Pulse Cladding Process

Effects of Coil Length on Tube Compression in Electromagnetic Forming

The Pressure on the Coil in Tube Electromagnetic Forming

Experimental study of tube ends sizing with electromagnetic bulging

Transient Distribution of Magnetic Pressure in Electromagnetic Tube Bulging

Study on magnetic pulse crimping process for joining large-diameter aluminum alloy tube/magnesium alloy shaft

Experimental and Numerical Research on Process Formability in Magnetic Pulse Forming of AZ31 Magnesium Alloy Sheets

Magnetic Pulse Joining of Aluminum Alloy–carbon Steel Tubes

Improving the uniformity and controllability of tube deformation via a three-coil forming system

Numerical study of flow and heat transfer behaviors during direct-chill casting of large-size magnesium alloy billet under pulsed magnetic field

Finite Element Analysis of Free Expansion of Aluminum Alloy Tube under Magnetic Pressure