Abstract:Blast furnace (BF) hydrogen-rich smelting is an important way for the green and low-carbon development of iron and steel industry. The injection volume of hydrogen-rich gas is limited due to the need for hearth activity, which is related to the stable and smooth operation of BF. In this study, the change of coke properties after hydrogen-rich smelting was summarized, the detailed evolution process of hearth activity after hydrogen-rich smelting was analyzed. The results show that: the pores on the surface of coke are enlarged after hydrogen-rich smelting. The gasification rate of coke with H 2O is significantly higher than that of CO 2 due to the lower activation energy and smaller molecular diameters of H 2O and H 2. The interlayer spacing of coke decreases and the stacking height further increases rapidly, the degree of coke graphitization is the highest after hydrogen-rich smelting. The weakening of carbon anisotropy is the fundamental reason for the increase in the degree of graphitization of coke. The strong gasification reaction causes the coke to lose a lot of carbon, and its matrix becomes loose and incomplete, so the strength after reaction decreases sharply. The wetting model is established to analyze changes in wettability. The rough surface of coke improves the wettability between slag iron and coke at high temperature. The good wettability makes it easier for slag iron to adhere to the surface of coke. The smoothness of slag iron passing through coke is reduced, the retention amount of liquid slag iron in coke layer increases. It leads to a decrease in hearth activity, the stable and smooth operation of BF is difficult to guarantee. This is the main issue limiting the injection volume of hydrogen-rich gas in BF.

Practice and Theoretical Analysis about Effect of H2 Content on Ironmaking Process

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Effects of Hydrogen-Enriched Reduction on Metallurgical Properties of Iron-Bearing Burdens Under BF Operation with COG Injection

EXPERIMENT STUDY ON THE EFFECT OF IRON ORE SINTER BEHAVIOR WITH ADDING BIOMASS

Effect of H2 on Blast Furnace Ironmaking: A Review

Effects of hydrogen-rich fuel injection on the states of the raceway in blast furnace

Effect of Hydrogen Addition on Softening and Melting Reduction Behaviors of Ferrous Burden in Gas-Injection Blast Furnace

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Numerical Investigation of Burden Distribution in Hydrogen Blast Furnace

Particle-scale Modelling of Injected Hydrogen and Coke Co-Combustion in the Raceway of an Ironmaking Blast Furnace

Effect of Hydrogen-Rich Atmosphere on the Reduction Behavior and Kinetics of Iron-Ore Pellets Under Non-isothermal Conditions

CFD study of hydrogen co-injection through tuyere and shaft of an ironmaking blast furnace

Evolution and process analysis of the hearth activity in hydrogen-rich blast furnace

Novel experimental method to simulate reduction behaviour of burden in blast furnace shaft

Numerical Simulation of the Effect of Feeding Mode on the Reduction of Ore Powder in Hydrogen‐Based Flash Ironmaking Process

Experimental and Modeling Study on Reduction and Heat Transfer Characteristics of Single Iron Ore Pellet in H<sub>2</sub>/CO Atmospheres

Calculation on effective heat of injected pulverized coal in blast furnace

Review of hydrogen-rich ironmaking technology in blast furnace

Co-injection of hydrogen and biochar (CoHB) in a simulated blast furnace: A univariate and multivariate study