Abstract:Abstract Background The motion capture has been used as the usual method for measuring movement parameters of human, and most of the measuring data are obtained by partial manual process based on commercial software. An automatic kinematics data process was developed by programming on MATLAB software in this paper. Methods The motion capture measurement of healthy volunteers was carried out and the MATLAB program was used for data process. Firstly, the coordinate data of markers and anatomical points on human lower limb measured by motion capture system were read and repaired through the usual and the patch program. Meantime, the local coordinate systems of human femur and tibia were established with anatomical points. Then flexion/extension, abduction/adduction and internal/external rotation of human knee tibiofemoral joint were obtained by special coordinate transformation program. Results Using the above methods, motion capture measurements and batch data processing were carried out on squatting and climbing stairs of 29 healthy volunteers. And the motion characteristics (flexion/extension, internal/external rotation and adduction/abduction) of the knee joint were obtained. For example, the maximum internal/external rotation in squatting and climbing stairs were respectively was 30.5 degrees and 14 degrees, etc. Meantime, the results of this paper also were respectively compared with the results processed by other research methods, and the results were basically consistent, thus the reliability of our research method was verified. After calibration processing, the compiled MATLAB program of this paper can directly be used for efficient batch processing and avoiding manual modeling one by one. Conclusion A novel Patch Program of this paper has been developed, which can make reasonable compensation for missing and noise signals to obtain more complete motion data. At the same time, a universal data processing program has also been developed for obtaining the relative movement of various components of the human body, and the program can be modified for detail special analysis. These motion capture technologies can be used to judge whether the human body functions are abnormal, provide a reference for rehabilitation treatment and design of rehabilitation equipment, and evaluate the effectiveness before and after surgery.

Human upper limb dynamic motion measurement based on multi-dimensional video system

Motion Parameters Measurement of User-Defined Key Points Using 3D Pose Estimation

2P1-A11 Measurement and Analysis of Upper Limb Movement of a Human Using Motion Capture

1A2-F01 Measurement and Analysis of Motion Cognition of Human Upper Limb by using Motion Capture

The Study on the Algorithm for Calculating Motion Parameters of Human Upper-limb Based on 3-D Camera Measurement System

3D Upper Limb Motion Modeling and Estimation Using Wearable Micro-sensors

[Measuring Human Arm Motion Parameters Based on High-Speed Camera].

Upper limb movement analysis via marker tracking with a single-camera system

A Real-Time Upper Limb Motion Estimation System

Dynamic Human Body Reconstruction and Motion Tracking with Low-Cost Depth Cameras

3 D Adaptive Reconstruction of Human Motion From Multi-Sensors

A wearable motion capture device able to detect dynamic motion of human limbs

Geometrical kinematic modeling on human motion using method of multi-sensor fusion

Spatial Reconstruction of Human Motion Utilizing Two Dimension Images and a Biomechanical Model

Wearable Sensors for 3D Upper Limb Motion Modeling and Ubiquitous Estimation

Joint motion measurement system based on Euler angle

A data process of human knee joint kinematics obtained by motion-capture measurement

3d Test And Reconstruction Of Human Motion Parameters From Video Sequences

[Human Motion Analysis System Based on Common Video-Camera].

Ubiquitous Human Body Motion Capture Using Micro-Sensors

Method to measure human upper-limb motion based on the electromagnetic tracking system