Abstract:Compared with the position sensor control, sensorless control avoids a lot of defects caused by the position sensor, at the same time makes the system more stability and stronger anti-interference performance, it has more advantages and meets control field's requirements better in the future, it has gradually become a hotspot in the brushless DC motor control field. The rotor position detection has been a very critical research in the brushless DC motor sensorless control. In this paper, a new type of rotor position detection method is proposed, which is based on the principle and mathematical model of a brushless DC motor after the analysis of advantages and disadvantages of the back EMF principle of zero-detection and the method of the back-EMF superposition, which means a combination of the method of the two rotor position detection, as above. This method neither need a delay of 30° nor require a depth filter, the hardware circuit is also simple and there is no need to compensate for the phase shift. Then, the frequency of the detection signal is three times of fundamental wave frequency in this method and the detection signal is easier to detect when the motor running at low speed, which expand the applicable speed range of the electric motor. This paper analyzes the principle and commutation logic of the rotor position detection method, it come up with a conclusion that the stagnation point of the three BEMF superposition derivative is the commutation points of the stator windings, and it uses the method of the back-EMF zero crossings to determine the current conduction state. The simulation model of the brushless DC motor's control system is established in MATLAB /Simulink it uses speed and current double close loop PI control. The result shows that the method is correct and feasible, it can get the right rotor position signal and control motor commutation correctly, the method can achieve the control of brushless DC motor without position sensor, and it can provide a reference for further research.

A Novel Position-Sensorless Method of BLDCM Utilizing Inductance Variation

A Novel Magnetization Failure Detection Method for 1-Phase BLDC Motor Based on Back-EMF Test

A Novel Starting Method of Sensorless BLDC Motors for Electric Vehicles

High-Frequency Signal Injection-Based Sensorless Control for Dual-Armature Flux-Switching Permanent Magnet Machine

A Novel Estimation Method of Sensorless Initial Rotor Position for Surface-mounted PMLSM

Checking method of initial position for surface-mounted permanent magnet linear synchronous motor

Position Sensorless Control of Surface-Mounted PMLSM with a Novel Starting Method

A Novel Sensorless Control System of Brushless DC Motors

Design of Dual Mode Brushless DC Motor Controller Based on Position Sensor or Sensorless

Design of Control System for BLDCM Without Position Sensor

Research for Brushless Motor Controller Using Winding Back-Emf to Detect Rotor Position

A Novel Rotor Position Detection Method for Sensorless Control of Magnetic-Geared Permanent-Magnet Brushless Motor

A Position Sensorless Control Strategy for the BLDCM Based on a Flux-Linkage Function

Sensorless control of BLDC motors using an improved low-cost back EMF detection method

Neural Network Control Of Electric Vehicle Based On Position-Sensorless Brushless Dc Motor

Study of direct back EMF detection for sensorless brushless DC motor

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

Quantitative Characteristic Comparison Between Sensorless Six Step and Field Oriented Control Methods for Permanent Magnet Brushless DC Motors

Rotor position detection based on BEMF zero-crossing detection method with three-EMF force superposition