Abstract:At present, cantilever structure used widely in civil structures will generate continuous vibration by external force due to their low damping characteristic, which leads to a serious impact on the working performance and service time. Therefore, it is very important to control the vibration of these structures. The active vibration control is the primary means of controlling the vibration with high precision and strong adaptive ability. Nowadays, there are many researches using piezoelectric materials in the structural vibration control. Piezoelectric materials are cheap, reliable and they can provide braking and sensing method harmless to the structure, therefore they have broad usage. They are used for structural vibration control in a lot of civil engineering research currently. In traditional sensor applications, information exchanges with the monitoring center or a computer system through wires. If wireless sensor networks(WSN) technology is used, cabling links is not needed, thus the cost of the whole system is greatly reduced.Based on the above advantages, a wireless control system is designed and validated through preliminary tests. The system consists of a cantilever, PVDF as sensor, signal conditioning circuit(SCM), A/D acquisition board, control arithmetic unit, D/A output board, power amplifier, piezoelectric bimorph as actuator. DSP chip is used as the control arithmetic unit and PD control algorithm is embedded in it. PVDF collects the parameters of vibration, sends them to the SCM after A/D conversion. SCM passes the data to the DSP through wireless technology, and DSP calculates and outputs the control values according to the control algorithm. The output signal is amplified by the power amplifier to drive the piezoelectric bimorph for vibration control. The structural vibration duration reduces to 1/4 of the uncontrolled case, which verifies the feasibility of the system.

Test and control system used in oscillation absorber test-bed

Development Of Automatic Vibration Calibration System

Control Designs for Multi-Exciter Power Spectral Density Replication Vibration Tests

The Development of the Static and Dynamic Performance Integrated Test System for Electro-hydraulic Servo Valve

An Automatic Testing System for Vehicle's Drive Axis Performance Test

Design and test analysis of rotary electro-hydraulic control system for a segment assembly test bed

Computer testing and controlling system of newly shock absorber testing system

Automatic Control System of Piston Thermal Shock Test Bench Based on Embedded PC

Intelligent Control of a Servo-Motor-Driven Shock Absorber Performance Tester

Active Pneumatic Vibration Control By Using Pressure And Velocity Measurements And Adaptive Fuzzy Sliding-Mode Controller

Control Strategy of Pneumatic Integrated Active and Passive Vibration Isolator

DSP-based Control System of a Mechanical Adaptive Tuned Vibration Absorber

Control of the Hydraulic Servo System Based on Double Close-loop Controller

Design and Experimental Research on Active Control System of Low Frequency Vibration

Research on Control Strategy for Simulation Working Condition Test-Bed of Magneto-Rheological Fluid Damper

Design of Fatigue Pulsation Test-bed Control System Based on Repetitive Control

Control system for an adaptive-active tuned vibration absorber based on magnetorheological elastomers

Experimental studies on active control of a dynamic system via a time-delayed absorber

Design And Initial Validation Of A Wireless Control System Based On Wsn

Adaptive Vibration Control on Electrohydraulic Shaking Table System with an Expanded Frequency Range: Theory Analysis and Experimental Study

Double-layer Vibration Suppression Bilinear System Featuring Electro-Rheological Damper with Optimal Damping and Semi-Active Control