Abstract:Compared to the linear frequency domain method, the transient Computational Fluid Dynamics (CFD) method is more effective when analyzing the effect of complex flow in the muffler on its acoustic characteristics. However, most of the existing CFD methods focus on the calculation of the transmission loss (TL) for the muffler only. The other evaluation parameters, such as noise reduction (NR), are rarely investigated. In this paper, a CFD approach was developed systematically for charactering TL, NR, and transfer matrix (TM) of the muffler in the cases without and with exhaust flow. In the proposed approach, only one mesh model with a correction pipe is needed based on two simulation runs. The non-reflective boundary was used as the termination of the correction pipe in the calculation for the TL, while the reflective pressure boundary was set on the correction pipe end in the calculation for the NR. The TM was then derived from the time-domain pressure and mass velocity obtained in the previous runs for calculating TL and NR. The proposed CFD approach was applied to two simple expansion chambers, and the computational predictions of TL, NR, and TM were validated successfully both with the measured results and the analytical results. In conclusion, the proposed CFD approach is effective for full characterization (TL, NR, and TM) of exhaust mufflers without and with exhaust flow.

Analysis on the Effects of Expansion Ratio on the Pressure Loss of Expansion Muffler

Numerical Simulation and Structure Optimization of Compressor Muffler

Numerical Analysis of Acoustic Characteristic of Muffler with Complicated Structure and Structural Optimization

Finite Element Method Simulation Analysis for Sound Field of Exhaust Muffler

Numerical Simulation of Serial Sudden Expansions Pipe Flow

Numerical Analysis on Acoustic Characteristics of Automotive Exhaust Muffler by Transfer Matrix Method

Numerical Analysis and Structure Improvement of Automotive Exhaust Muffler's Acoustic Characteristics

Research on relation among inlet/outlet pressure, pressure loss and inlet velocity of a complex resistance muffler

Numerical simulation and test validation for performance of a muffler in an exhaust pipe

Modal Analysis and Structure Design for Hydraulic Muffler

Research on the Influence of Characteristics of the Annular Connecting Pipe on the Transmission Loss of the Expanded Exhaust Muffler

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Simulation and Improvement of Silencer at Turbocharger Outlet

Exhaust Muffler Design Based on CFD

A Computational Fluid Dynamics Approach for Full Characterization of Muffler Without and with Exhaust Flow

Test and Numerical Simulation for Fluid Dynamic Characteristics of Dual Mode Mufflers

Theoretical Study on a Water Muffler

Theoretical and Experimental Study on the Transmission Loss of a Side Outlet Muffler

Loss of a Side Outlet Muffler

A Study on the Numerical Simulation Method for the Acoustic Performance of Exhaust Catalytic Muffler

Numerical Simulation and Experimental Study of SCR Convertor Muffler Assembly