Abstract:Iron-based shape memory alloys (FeSMA) are emerging as promising materials for use in post-tensioning concrete structures to provide self-centering capabilities during a seismic event. Past experimental studies on FeSMA focused on strengthening or repairing existing structural components. In addition to the structural rehabilitation for gravity loading, FeSMA also have potential for use in self-centering columns subjected to seismic loads. However, the basic material properties, such as strength, ductility, recovery strain, actuation stress (i.e., prestress) stability, low-cycle fatigue resistance, and temperature dependence of FeSMA related to self-centering column applications have not been studied so far. To fill this knowledge gap and determine the feasibility of using FeSMA in self-centering columns, this study performed a comprehensive characterization and analysis of FeSMA both before and after actuation (i.e., thermal stimulation). The strength, ductility, and recovery strain of FeSMA before actuation were tested at different temperatures from -40°C to 50°C. After actuation, the actuation stress, low-cycle fatigue resistance, and strain capacity of FeSMA were tested at different temperatures from -40°C to 50°C, prestrain levels from 4% to 30%, and under low-cycle fatigue loading with strain amplitudes from 0.5% to 1.0%. The results from this study demonstrated that FeSMA exhibit high ductility, cyclic actuation stress stability, and low-cycle fatigue resistance at temperatures from -40°C to 50°C. Furthermore, it was found that increasing the prestrain level can effectively increase the post-actuation strain amplitude at which the actuation stress reduces to zero. A prestrain level between 15% and 20% is recommended for application of FeSMA in self-centering columns. The research findings from this study demonstrated the feasibility of using FeSMA in self-centering columns subject to seismic loading.

Behavior of Concrete Driven by Uniaxially Embedded Shape Memory Alloy Actuators

Modelling and Experimental Study of Shape Memory Alloys Coil Spring Actuator

Uniaxial Compressive Behavior of Concrete Columns Confined with Superelastic Shape Memory Alloy Wires

Behavior of Smart Concrete Beams with Embedded Shape Memory Alloy Bundles

Numerical Analysis and Design of Concrete-Filled Wire Arc Additively Manufactured Steel Tube under Axial Compression

Experimental investigation on hysteretic properties and applications in beam-column connections of shape memory alloy plates

Study on flexural and self-repairing properties of shape memory alloy concrete beams

Vibration Control of Cylindrical Shell Panel with Shape Memory Alloy Actuators

The application of shape memory alloy technology in steel, timber and concrete connectors

Monitoring of a Smart Concrete Beam

Study on reinforced concrete beams strengthened using shape memory alloy wires in combination with carbon-fiber-reinforced polymer plates

The effect of shape memory alloys on the ductility of exterior reinforced concrete beam-column joints using the damage plasticity model

Mechanical Behavior of Shape Memory Alloy Fibers Embedded in Engineered Cementitious Composite Matrix under Cyclic Pullout Loads

Tests on Pretrained Superelastic NiTi Shape Memory Alloy Rods: Towards Application in Self-Centering Link Beams

Tensile Test of Shape Memory Alloys and Numerical Simulation

Bending Deformation of Shape Memory Alloy Hybrid Composites

Potential of Fe-Mn-Al-Ni Shape Memory Alloys for Internal Prestressing of Ultra-High Performance Concrete

Material characterization of iron-based shape memory alloys for use in self-centering columns

Experimental Study of Superelasticity of Ni-Ti Shape Memory Alloy Wires

The study on bond-slip constitutive model of shape memory alloy fiber-reinforced concrete

Bond behavior of iron-based shape memory alloy reinforcing bars embedded in concrete