Abstract:Vitrification is a promising treatment for municipal solid waste incineration fly ash (MSWI-FA); however, high energy consumption due to the high MSWI-FA fusion temperature limits the development and application of this technique. In this study, fine slag ash (FSA) derived from coal gasification and coal gangue ash (CGA) were mixed with MSWI-FA to reduce the ash fusion temperature. The transformation of minerals in ash during thermal treatment was examined via X-ray diffraction and thermodynamic equilibrium calculations. The ash flow behaviour was observed using a thermal platform microscope, and the silicate structure was quantified using Raman spectra. The co-melting mechanisms for the mixed ash were systematically investigated. Results indicate that the flow temperature (FT) of the mixed ash exhibited an initial decrease and subsequent increase as a function of the addition ratio of FSA or CGA. Lowest ash FT of 1215 °C and 1223 °C were recorded for addition of 50% FSA and 50% CGA, respectively; further, these temperatures were lowered by > 285 °C and >277 °C respectively, relative to FT of the MSWI-FA. The transformation of minerals and silicate structure during mixed ash heating was responsible for the variation in the ash fusion temperature. CaO in MSWI-FA tended to react with mullite, quartz and haematite in FSA and CGA, forming minerals such as anorthite, gehlenite, and andradite with relatively low melting points. The addition of FSA or CGA caused changes in the silicate network structure of the mixed ash. In particular, 50% FSA incorporation caused the transformation of Q4 and Q3 to Q2, whereas 50% CGA introduction resulted in the conversion of Q4 and Q2 into Q3 and Q1 + Q0, respectively. The silicate network depolymerised, causing reduction in the ash fusion temperature and increasing the melting rate.

Application of Ash Agglomeration in Garbage Firing Internally Circulating Fluidized Beds

Examination of Industrial Demonstration Unit of Coal Gasification for Pulverized Coal with Ash Agglomeration Technique

Experimental Study on Discharge of Agglomerates in MSW Incinerators with Internally Circulating Fluidized Beds

Mechanism of Na2O/CaO Ratio Affecting Ash Fusing Characteristics During Ash Deposition and Slagging in Municipal Solid Waste Incinerator

EXPERIMENTAL STUDY ON PARTICLE MOTION CHARACTERISTIC IN THE INTERNAL CIRCULATING FLUIDIZED BED

Agglomeration characteristics in fluidized bed incineration of organic-condensed wastewater

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Co-melting mechanisms for municipal solid waste incineration fly ash with fine slag from coal gasification and coal gangue

Compositions And Fusibility Of Ash And Slag In Municipal Solid Waste

Optimization of Deposition Prevention Structure of a Grate Type Municipal Solid Waste Incinerator Based on CFD Numerical Simulation

High temperature melting of municipal solid waste incineration (MSWI) fly ash and co-disposal technology with blast furnaces

Decarburization and ash characteristics during melting combustion of fine ash from entrained-flow gasifier

Pilot test of heat transfer in solid waste control oxygen

Study on Drying and Combustion Process in Grate-Cfb Incinerator

Combustion Characteristics of Particles of Hazardous Solid Waste Mixtures in a Fixed Bed

Ash Melting Technology and Application in MSW Gasification and Melting System

On-the-spot Test of the Slagging in a Grate-circulating Bed Garbage Incinerator Superheater

Evolution of Fusion and PCDD/F-signatures of Boiler Ash from a Mechanical Grate Municipal Solid Waste Incinerator

Investigations on the Mechanisms of Ash-Induced Agglomeration in Fluidized-Bed Combustion of Biomass

EXPERIMENTAL STUDY ON FLUIDIZED BED AGGLOMERATION COMBUSTION USING FLY-ASH SLURRY WITH HIGH CARBON CONTENT AND COAL-WATER MIXTURE AS FUELS

High-Temperature Ash Melting and Fluidity Behavior upon the Cocombustion of Sewage Sludge and Coal