Abstract:This study used the horizontal tubular heating furnace to explore the melting potential of circulating fluidized bed (CFB) incinerator fly ash and mechanical grate furnace (MGF) incinerator fly ash. The horizontal cyclone melting furnace was then built to explore further the feasibility of scale melting of MSWI fly ash. The melting characteristic temperature, amorphous content, and heavy metal leaching concentration characterized the melting potential and solidification effect of MSWI fly ash. The experimental results show that the amorphous content of CFB fly ash after melting is up to 92.37%, and the volatilization rate of heavy metals Zn, Pb, and Ni does not exceed 30%. MGF fly ash exhibits the "sintering into shells" phenomenon during heating, and the leaching concentrations of heavy metals Pb in the sintered products still exceed the standard limits. In addition, the volatilization rates of heavy metals Cu, Zn, Cd, Pb, Cr, and Ni in Slag II are above 50%, and the volatilization rate of Cr reaches 85%. So, slag's amorphous content also affects heavy metals' volatilization rate. The MSWI fly ash melting characteristic temperature decreases with the decrease of alkalinity value. When the alkalinity value drops to 0.6, the melting characteristic temperature reaches its lowest value. Mixing 80% CFB fly ash or 50% MGF bottom ash into MGF fly ash can significantly enhance the melting potential to reduce hazardous waste. When using the horizontal cyclone melting furnace to process MSWI fly ash on a large scale, MSWI fly ash achieves an excellent melting effect with an amorphous content of over 93% at the positions of the furnace middle section, inner tail cone, slag discharge outlet, and flue gas outlet. The fly ash particles are in motion in the melting furnace, so the particle size distribution affects the melting effect of MSWI fly ash.

Ash Melting Technology and Application in MSW Gasification and Melting System

Research on Low Emission MSW Gasification and Melting System

Experimental study on MSW gasification and melting technology

Discussion on the Gasification and Melting Technology of MSW

MSW Incineration Residue Melting Technology

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Experimental Study and Simulation of Low-Temperature Gasification of Municipal Solid Waste in Circulated Fluidized Bed

Application of microwave heating in disposal and utilization of MSW fly ash

Municipal Solid Waste Gasification Technique

Gasification and Melting Characteristics of MSW in China

A Steam Dried Municipal Solid Waste Gasification and Melting Process

Theoretical Calculation and Analysis on the Gasification and Melting Process of MSW with Oxygen-Enriched Air

Component Analysis of Municipal Solid Waste Incineration (MSWI) Ash and Its Melting Characteristics

Compositions And Fusibility Of Ash And Slag In Municipal Solid Waste

Co-melting mechanisms for municipal solid waste incineration fly ash with fine slag from coal gasification and coal gangue

The mineral transformation and molten behaviors of biomass waste ashes in gasification-melting process

Process exploration for scale melting and solidifying of municipal solid waste incineration (MSWI) fly ash by horizontal cyclone melting furnace

High temperature melting of municipal solid waste incineration (MSWI) fly ash and co-disposal technology with blast furnaces

Modification of Melting Combustion Kinetic Model of Fine Ash from Entrained-Flow Gasifier

Basic Research on Co-treatment of Municipal Solid Waste Incineration Fly Ash and Municipal Sludge for Energy-Saving Melting

Vitrification of municipal solid waste incineration fly ash using biomass ash as additives.