Abstract:Understanding the void defect formation mechanism and simultaneous predicting the tool service life in friction stir welding are critical for optimizing the welding parameters. However, the void defect formation mechanism in friction stir welding is not yet elucidated. In this study, a novel integrated thermal-fluid-structure coupling model of the friction stir welding process was proposed for simultaneous prediction of the weld formation and tool service life. A new non-uniform distribution model of the tool-workpiece contact pressure was proposed to describe the interaction between the tool and the workpiece. The void defect formation mechanism was quantitatively studied using the proposed integrated thermal-fluid-structure coupling model. The results show that the plastic material flows in the horizontal direction and can completely fill the cavity behind the tool for the welding condition of forming a sound weld. While the tool-workpiece contact interfacial frictional shear stress in the rear of the tool is decreased significantly which leads to a severe decrease in the plastic material flow velocity. Therefore, after bypassing the tool from the retreating side, the plastic material at the bottom of the weld stagnates, and void defect forms in the middle and lower part of the weld at the advancing side. The difference between the maximum and the minimum tool-workpiece contact pressure could serve as a numerical criterion to predict void defects. A sound joint is formed when the difference is lower than the critical value of 15 MPa, while a void defect is formed in the weld if it is higher than this critical value. The maximum equivalent stress acting on the tool is located at the pin root with severe stress concentration at a high welding speed. The front of the tool is subjected to tensile stress while its rear is subjected to compressive stress, therefore the tool is apt to fracture at its root under an inappropriate welding condition. The average normal stress of the tool varies periodically with its period consistent with the rotation period of the tool. The service life of the tool is decreased with the increase in welding speed and the decrease in rotation speed. The model is validated by experimental results.

Simulation of Welded Flaws Based on Life-death Element Technique

Low Cycle Fatigue Properties and Fracture Mechanism of Q345qC Steel and Its Welded Joint

DAMAGE ACCUMULATION, FRACTURE AND POST FRACTURE ANALYSES FOR INITIALLY FLAWED STEEL STRUCTURES

Application of Computer Finite Element Simulation to the Quantitative Inspection of Flaw MFL

Finite element simulation of welding process and real-time monitoring assessment

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

Numerical Simulation on Fracture Mechanics Parameters of Welded Joint with Damage

NUMERICAL SIMULATION OF FAILURE BEHAVIOR OF REINFORCED CONCRETE FRAME STRUCTURES BY DISCRETE ELEMENT METHOD

Numerical simulation of interference of fatigue growth of co-plane cracks

A simulation of fatigue crack propagation in a welded T-joint using 3D boundary element method

Nonlinear Numerical Simulation of Welding Heat-Cycle and Its Application in Welding Heat Simulation

Numerical Simulation of Welding Stresses and Distortions Based on 3D Dynamic Substructure Method

A spot weld element formulation and implementation for mesh‐insensitive fatigue evaluation of lightweight structures

Numerical simulation of distortion-induced fatigue crack growth using extended finite element method

Three Dimensional Modeling Weld Solidification Cracks in Multipass Welding

Investigation of the Quality Category Approach for BS7910-based Rapid Fatigue Assessment of Welded Structures Containing Cracks

An Implicit Fillet‐Weld Element Formulation for Mesh‐Insensitive Fatigue Evaluation of Complex Structures

Quantitative Relationship Between Weld Defect Characteristic and Fatigue Crack Initiation Life for High-Cycle Fatigue Property

Thermal-fluid-structure coupling analysis of void defect in friction stir welding

Three-Dimensional Numerical Simulation of Weld Solidification Cracking

Reliability Analysis of Clamp Welding Defects Based on Finite Element Simulation