Abstract:In modern warfare, the advancement of low detectable technology has made the reduction of an aircraft radar cross section (RCS) crucial for survivability, while engine inlets significantly impact the overall detectability index as major forward scattering sources. Inspired by radar absorbing structures (RASs) based on metasurface theory, as well as the spoof surface plasmon polariton (SSPP) theory, this paper proposes a comprehensive design of radar absorbing grilles (RAGs) which are installed at the inlet aperture of the aircraft intake, where RAGs allow airflow to cross through and absorb the detecting radar wave. To enhance the ability of electromagnetic wave attenuation, an indium tin oxide (ITO) film is added in the middle of the RAGs to change the impedance characteristics. This study clarifies the mechanism influencing radar wave absorption characteristics through design parameters (unit length and sheet resistance) and radar characteristic parameters (frequency, incident angle, and polarization mode). The absorption peak gradually shifts towards lower frequencies with the increase in unit length from 8 to 16 mm of the grille. The integrated average absorption first increases and then decreases with the increase in sheet resistance from 100 to 800 Ω/□ applied as ITO film in the middle of the grille. When the unit length of RAG is 12 mm and 400 Ω/□, the sheet resistance is applied, and a 90% absorption bandwidth is achieved to 100% within the 8–18 GHz band. The 90% absorption bandwidth reaches 72.3% in the 2–18 GHz band while maintaining absorption above 40% in the 2–8 GHz band. The integrated average absorption reaches 0.887, and the 90% absorption bandwidth increases to 255.6% of the original model's bandwidth. The results indicate that the proposed RAGs based on metasurface exhibit broadband absorption performance and high angular stability, providing technical support for further application of these grilles in aircraft engine inlets.

Electromagnetic Scattering Characteristics of Serpentine Inlet

Research on electromagnetic scattering and plasma stealth design of S-shaped inlet

Electromagnetic Scattering of a Submerged Inlet

Analysis of the scattering characteristic for the hypersonic flow field of semi-sphere

Analysis of the Scattering Characteristic for the Hypersonic Flow Field with Near Wake Region of Sphere

Serpentine Inlet Design and Analysis

Analysis of Scattering for the Flow Field of Reentry Blunted Cone

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

A Wideband Transmission Frequency Selective Surface Rasorber

Tapered Resistive Sheets Loading to the FSS Absorber for the Wide-Angle Monostatic RCS Reduction Applications

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

Study on Novel Radar Absorbing Grilles of Aircraft Engine Inlet Based on Metasurface Design Theory

Enhanced High-gain Antenna Design with Phase-Controlled Frequency Selective Rasorber for LowRCS Performance

Tapered resistive sheets and FSS absorber loading for the wide-band RCS reduction of the elliptic surface at TM polarization

Research on the RCS characteristics of blunt-cone with slots and plasma sheath

Attenuation Of Electromagnetic Waves By Plasma-Covered Cavity

EM Design and Analysis of Frequency Selective Surface Based on Substrate-Integrated Waveguide Technology for Airborne Radome Application

Partition Layout Loading of Frequency Selective Surface Absorbers on the Curved Surfaces for the Significant RCS Reduction