Heat, mass and momentum transport in wet mineral-wool insulation: Experiment and simulation
Fan Lu,Massoud Kaviany,John Williams,Thomas Addison-Smith
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.125644
IF: 5.2
2024-05-19
International Journal of Heat and Mass Transfer
Abstract:To test the performance of wet mineral-wool insulation, a water submersion setup is used to monitor its heat transfer sequentially through dry, submerged, and drainage-drying periods. A cylindrical-shell insulation is wrapped around a pipe carrying a preheated (over 100 °C) oil stream. The temperature at various locations is monitored, and after a few hours in each period, steady-state conditions are reached. Numerical 2-D (with gravity) simulations of the transient, simultaneous heat, mass, and momentum transport are also performed, with the control of the insulation hydrophobicity through the insulation surface liquid saturation. The distributions of temperature, liquid saturation, liquid and vapor velocity, vapor mass fraction, and evaporation rate, are predicted as well as the total heat flow through the dry/wet insulation. The predicted heat flow rate and temperature distribution within the insulation, through the three periods, are in good agreement in heat flow rate and temperature distributions with the test results (maximum difference of 20 %). The predicted 2-D liquid saturation shows that gravity and capillary pressure play significant roles in the liquid distribution and the insulation hydrophobicity changes with temperature due to the dissolution of the hydrophobic fiber coating. The presence of a gap between the pipe and insulation plays a significant role in heat transfer during the submerged period, as it allows for continuous direct liquid contact with the pipe. During the drying period, the evaporation rate continuously decreases (with a decrease in the average liquid saturation), governed by the increasing resistances to the heat and liquid flow.
engineering, mechanical,thermodynamics,mechanics