Effect of Heat Treatment on Structure and Properties of B Alloyed High Speed Steel for Rolling Mill Rolls
H. G. Fu,Z. Z. Du,Y. Jiang,P. Li,R. Zhou,Q. H. Cen,Y. P. Lei,J. D. Xing
DOI: https://doi.org/10.4149/km_2013_3_189
2021-01-01
Kovove Materialy-Metallic Materials
Abstract:Solidification structure of two kinds of B alloyed high speed steel for rolling mill rolls, which carbon contents are 0.50 % and 1.00 %, respectively, and the changes in the microstructure and mechanical properties after quenching from 1050 degrees C and tempering at 200-600 degrees C, respectively, are studied. The results of metallographic, scanning electron microscopy analysis, X-ray diffraction analysis, hardness and impact toughness measurements of as-cast and heat-treated B alloyed high speed steel are discussed. As-cast matrix of B alloyed high speed steel consists of martensite and troostite. There are 19-26 vol.% M-23 (B, C)(6), M-23 (B0.7C0.3) and M-2(B, C) type carboborides in the matrix. Microhardness values of M-23 (B, C)(6), M-23(B0.7C0.3) and M-2 (B, C) are 1940-2030 HV, 1380-1460 HV and 1460-1530 HV, respectively. Macrohardness of as-cast B alloyed high speed steel reaches 58-60 HRC. After quenching from 1050 degrees C, the eutectic M-23 (B, C)(6) and M-23 (B0.7C0.3) carboborides dissolve into the matrix, and many granular M-23 (B, C)(6) precipitate from the matrix, and the whole matrix transforms into martensite. Microhardness of matrix and macrohardness of quenched B alloyed high speed steel have a slight increase comparing with as-cast sample. Hardness of the B alloyed high speed steel remains constant while tempering temperature is below 550 degrees C, and then, with increasing temperature, decreases considerably. Impact toughness of the B alloyed high speed steel increases slightly until tempering temperature reaches 525 degrees C, and then increases considerably. B alloyed high speed steel has higher hardness and has an excellent wear resistance after tempering under 550 degrees C that can be attributed to the effect of boron.