Abstract:Experimental study of air natural convection in horizontally-positioned copper metallic foams with open cells was conducted. Temperature distributions on the heating surface were tested under different heating power for foam samples having different porosities and pore densities. The effects of porosity and pore density on the total thermal resistance of the foam sample were quantified. It is found that the porous surface can enhance the natural convection and reduce the thermal resistance by about 20% in comparison with a smooth surface. The surface area density and mass flow rate in natural convection are affected by porosity and pore density simultaneously. When the porosity is relative small (ε = 90%), there exits a critical value of the Gr number (turning point) for two pore densities (10ppi and 40ppi). When the Gr number is less than this critical value, the foam with a higher pore density has the lower total thermal resistance, whereas when the Gr number exceeds the turning point value, the opposite holds. If the porosity is increased to ε = 95%, the foam with a higher pore density has the lower thermal resistance in the whole experimental range. When the porosity and pore density is the same, the foam with smaller size has the higher thermal resistance in the whole experimental range. If the size is relatively small (10010050mm), for the two pore densities studied (20ppi and 80ppi), there exits a critical value of the Gr number (turning point). The foam with a lower porosity(ε = 90%) has the lower thermal resistance and the decrease is more obvious for the case of 80ppi.If the size is relatively big(10010080mm),there exists a critical value of the Gr number (turning point) only for the case of 10ppi. When the Gr number is less than this critical value, the foam with a higher porosity (ε = 95%) has the higher total thermal resistance, the opposite holds. While for the other two pore densities (20ppi and 40ppi), there is no turning point. The foam with a higher porosity (ε = 95%) has the higher total thermal resistance in the whole experimental range. © 2011 IEEE.

Electrical Conductivity of Open-Cell Fe–Ni Alloy Foams

Investigation of the Electrical Conductivity of Open-cell Aluminum Foams

Effect of the Solid Phase Diffusion on the Mechanical Properties of Open-Cell Fe-Ni Alloy Foams

Electrical Conductivity of Aluminium Alloy Foams

Compressive Property and Energy Absorption Characteristic of 3D Open-Cell Ni–Cr–Fe Alloy Foams under Quasi-Static Conditions

Synthesis and Properties of Open-Cell Ni–Cr–Fe–Al Alloy Foams by Pack Co-Deposition Process

Natural Convection In Metal Foams With Open Cells

A Simulation Method to Evaluate Electrical Conductivity of Closed-Cell Aluminum Foam

The Temperature Dependence of Effective Thermal Conductivity of Open-Celled Steel Alloy Foams

Microstructure, Oxidation Resistance and High-Temperature Strength of a New Class of 3D Open‐cell Nickel-Based Foams

Investigation of Tensile Properties and In Situ Analysis of Fracture Behavior in High-Porosity Open-Cell Nickel Foam

Tomography-based Pore Level Analysis of Combined Conductive-Radiative Heat Transfer in an Open-Cell Metallic Foam

Synthesis and mechanical properties of open-cell Ni-Fe-Cr foams

Electromagnetic Shielding Properties of Open-Pore Fe-Ni Foams

Thermal radiation in ultralight metal foams with open cells

High Power Density & Energy Density Li-ion Battery with Aluminum Foam Enhanced Electrode: Fabrication and Simulation

Investigation of FeNi alloy foams at high oxygen evolution reaction rates using a dry anode setup in alkaline environment

Experimental study of natural convection in horizontally-positioned open-celled metal foams

Preparation of Electrodeposited Foam Fe-Ni Alloy Coating with Low Content of Nickel

Heat Transfer Analysis for Open Cell Metallic Foams

A Lattice Monte Carlo analysis of the effective thermal conductivity of closed-cell aluminum foams and an experimental verification