Abstract:Particle flocculation in a stirred tank was numerically investigated by a coupled CFD-DEM approach, in which a microscopic test in a typical zone was first proposed instead of solving the full-scale particle field. The flocculation kinetics was described by the Johnson-Kendall-Roberts (JKR) theory, followed by calibration of surface energy parameter. A Volume of Fluid (VOF) model was employed to capture the interface between liquid and air. The two-way coupling of fluid and particle was achieved by resolving pressure gradient force and Gidaspow’s drag force in the momentum equations. Based upon the qualitative and quantitative validation tests in air-water interface pattern and fluid tangential velocity, respectively, the particle coordination number and flocs fractal properties (e.g. fractal dimension, voidage, effective density) were investigated considering the effect of impeller speed. Results show that the number of particles first increases with particle coordination number and then decreases, and is further positively correlated with the stirring intensity in lower coordination numbers (0−3) while negatively correlated in higher coordination numbers (≥5). The influences of turbulence dissipation rate on the average particle coordination number were also investigated in radial, tangential, and axial directions. The mean floc size decreases with impeller speed, however, the fractal dimension increases in a certain range. The voidage increases with the daughter-particle number in a floc while the effective density of flocs is inversely proportional to the floc size. It is recommended to adopt operations that facilitate the one-by-one attachment mode and syneresis for forming relatively large and compact flocs.

Characteristics of the Dynamic Distribution of Suspended Particles in the Flocculation Process

Research on Distribution Characteristics of Floc Particles and Simulation of Flow Field in Flocculation Process

Characterization of the Flocculation Process from the Evolution of Particle Size Distributions

Analysis of Floc Morphology in a Continuous-Flow Flocculation and Sedimentation Reactor

Study on Influence Factors in Flocculation Conditions of Bioflocculant

Characteristic Analysis on Morphological Evolution of Suspended Particles in Water During Dynamic Flocculation Process

Characteristic Analysis on Temporal Evolution of Floc Size and Structure in Low-Shear Flow.

Optimization of Hydraulic Condition on Flocculation for Micro-polluted Water

Modeling Particle‐size Distribution Dynamics in a Flocculation System

Suspended Solid Abatement in a Conical Fluidized Bed Flocculator

Influential factors of formation kinetics of flocs produced by water treatment coagulants.

Interface dynamics in dewatering processes of high-water-content slurry flocculated with PAC

Dynamic aspects of coagulation and flocculation

Removal of Superfine Particulates From Wastewater by Enhanced Flocculation

Application of Particle Countering in Flocculation Process of Water Treatment

Particle flocculation in a stirred tank: A microscopic test by coupled CFD-DEM approach

Effect of Hydrodynamic Breakage on Floc Evolution and Turbidity Reduction in Flocculation and Sedimentation Processes

Removal of Particles Through Floc Breakage and Re-Growth at Low Temperature

Breakage and Re-Growth of Flocs Formed by Alum and PACl

Experimental and numerical characterization of floc morphology: role of changing hydraulic retention time under flocculation mechanisms

Characteristics of flocs formed by polyaluminum chloride during flocculation after floc recycling and breakage