Abstract:Interfacial dilational rheology is one of the important means to explore the interfacial properties of adsorption films. In this paper, the interfacial rheological properties of the mixed system of sulfobetaine ASB with a linear alkyl group and two anionic surfactants, petroleum sulfonate (PS) and alkyl polyoxyethylene carboxylate (AEC), were investigated by interfacial dilational rheology. The effect of the introduction of polymer hydrophobically modified polyacrylamide (HMPAM) on the interfacial properties of the mixed system was analyzed. In this experiment, the surfactant solution was used as the external phase and n-decane was used as the internal phase. A periodic sinusoidal disturbance of 0.1 Hz was applied to the n-decane droplets, and the changes of parameters such as droplet interfacial tension and interfacial area were monitored in real time with the help of a computer. The results show that the betaine ASB molecule responds to the dilation and compression of the interface through the change of ion head orientation, while the feedback behavior of petroleum sulfonate PS and AEC molecules embedded with oxygen vinyl groups in the molecule is diffusion and exchange between the interface and the bulk phase. Therefore, the interface film formed by ASB alone is higher, and the film formed by PS and AEC molecules alone is relatively lower. After adding two kinds of anionic surfactants to the betaine system, the ionic head of PS or AEC molecules will be attached to the positive center of the hydrophilic group of ASB molecules by electrostatic attraction and no longer adsorb and desorb with the interface deformation. The interfacial rheological properties of the compound system are still dominated by betaine, with higher dilational modulus and lower phase angle. When a small amount of HMPAM is added, or the content of hydrophobic monomer AMPS in the bulk phase is low, the intermolecular interaction at the interface is enhanced, the slow relaxation process is intensified, and the interfacial film strength is increased. As the content of AMPS further increases, hydrophobic blocks and surfactant molecules will form interfacial aggregates similar to mixed micelles at the oil-water interface, which will regulate the properties of the film by affecting the adsorption of surfactants at the interface. As long as the interfacial tension is the same, the properties of the interfacial film are the same. Based on the colloid interface science and the background of enhanced oil recovery, this study provides a reference for the field application of chemical flooding formulations.

Effect of Shengli Crude Oil Fractions on Dilational Rheological Properties of Interfacail Films

Dilational Rheological Properties of Surfactants at the Crude Oil-Water Interface: The Effect of Branch-Preformed Particle Gels and Polymers.

Effect of Heavy Constituent in Crude Oil on Wettability Change of Sandstone

A study of dilational rheological properties of polymers at interfaces

Experimental study on the effect of high water cut on the emulsifying properties of crude oil

Effect of Short Alkyl Chain on Interfacial Properties of Poly-Substituted Alkyl Benzene Sulfonate

Study on the indigenous stabilization mechanism of light crude oil emulsions based on an in situ solvent-dissolution visualization method

Effect of Polar Molecule Aggregation on the Stability of Crude Oil/Water Interface: A Molecular Simulation Study

The Interfacial Dilational Rheology Properties of Betaine Solutions: Effect of Anionic Surfactant and Polymer

Structure-activity relationship of anionic-nonionic surfactant for reducing interfacial tension of crude oil

Investigation on the mechanism of heating effect influencing emulsifying ability of crude oil: Experimental and molecular dynamics simulation

Study on the influence of SARA fraction in heavy oil on the oil recovery during water flooding by experiments and the molecular dynamics simulation

Investigation of Fluid-Fluid interaction between surfactant-ion-tuned water and crude oil: a new insight into asphaltene behavior in the emulsion interface

Effects of zwitterionic surfactant adsorption on the component distribution in the crude oil droplet: A molecular simulation study

Study on the Interactive Effects of Solid Particles and Asphaltenes on the Interfacial Structure and Stability of a Water-in-Model Oil Emulsion

Interfacial performance of cationic, anionic and non-ionic surfactants; effect of different characteristics of crude oil

Molecular insights into the dispersibility of asphaltene and crude oil rheological properties under the effect of multi-alkylated aromatic amides

Effect of Water Fraction on Rheological Properties of Waxy Crude Oil Emulsions

Study on Synthesis and Performance of Lignin Polyether Sulfonate Surfactants for Enhanced Oil Recovery

A molecular study of viscosity-causing mechanism and viscosity reduction through re-emulsification for Jimsar shale oil

Behavior of Emulsification and Thickening of Crude Oil in Mixed Cationic and Anionic Surfactant Systems