Abstract:Ultra-thin overlays (UTOL) are a standard highway pre-maintenance method used to improve the road surface performance of asphalt pavements and to repair minor rutting and cracking. However, the thin thickness makes it very sensitive to external changes, which increases its wear and shortens its life. So, this paper aims to prepare a durable and skid-resistance asphalt ultra-thin overlay using epoxy asphalt (EA) and steel slag. First, the physical properties of EA were characterized by penetration, softening point, flexibility, and kinematic viscosity tests. The dynamic shear rheometer (DSR) test characterizes EA's rheological properties. Differential Scanning Calorimetry (DSC), kinematic viscosity, and Fourier transform infrared spectroscopy (FTIR) characterized the EA's curing process. Finally, the pavement performance of an epoxy ultra-thin overlay (EUTOL) prepared with EA and steel slag was tested. The results show that the epoxy resin particles increase with the increase in epoxy resin dosage, and at 40%, its epoxy particles are uniformly distributed with the most significant area share. With the addition of epoxy resin, the needle penetration of EA decreases and then increases, the flexibility decreases at a slower rate, and the softening point rises significantly. Moreover, the growth of the elastic component in EA significantly improved the high-temperature viscoelastic properties. Considering its physical and rheological properties, the optimal doping amount of 40% was selected. By analyzing the curing behavior of EA (optimum dosage), the combination temperature of EA is 150 °C, which meets the needs of mixing and paving asphalt mixtures. After 12 h of maintenance at 120 °C, its reaction is sufficient. The skid-resistance durability, high-temperature, low-temperature, water stability, and fatigue resistance of UTOL can be effectively improved using steel slag coarse aggregate.

Development of Ceramic Thermal Resistance Wearing Course Materials and Performance Test

Performance and Thermal Evaluation of Incorporating Waste Ceramic Aggregates in Wearing Layer of Asphalt Pavement

Performance of Road Marking Materials Incorporated Waste Ceramic Particles

Enhanced Thermal Insulation of Steel Slag Based on Ultrathin Friction Course with Ceramic Fiber

Research on Preparation and High Temperature Behavior of High-Modulus Asphalt

Development of Water Retentive and Thermal Resistant Cement Concrete and Cooling Effects Evaluation

Experimental investigation on the performance of the asphalt mixture with ceramic fiber

Development of Super Road Heat-Reflective Coating and Its Field Application

Preparation and Properties of New Thermal Reflective Coating for Asphalt Pavement

Investigation of the Performance of Ceramic Fiber Modified Asphalt Mixture

Study on the performance of lightweight roadway wall thermal insulation coating containing EP-GHB mixed ceramsite

Study on Mechanism and Performance of Tack and Seal Coat of Thermal Resistance for Asphalt Pavement

Characteristics of Ceramic Fiber Modified Asphalt Mortar

Study on the Performance of Epoxy-Modified Asphalt and Steel Slag Ultra-Thin Friction Course

Performance analysis of thermally and non-conductive cement mortar prepared from waste iron scraps and magnetite sand

Study on the Photothermal Performance of a "Thermal Shielding" Coating Using Tungsten Bronze as Functional Material for Asphalt Pavement

Enhancing thermal conductivity of cement-based composites by optimizing pores and adding pitch-based carbon fibers for pavement cooling

Experimental investigation on performance of composite thermochromic and ice-melting coatings for dynamic pavement temperature control

Building the cooling roads with high thermal conductivity pavements to relieve urban heat island effect

Study on preparation and thermal performance improvements of composite phase change material for asphalt steel bridge deck

Material Design and Performance Analysis of the Anti-Ice and Antiskid Wear Layer on Pavement