Adsorption Behavior Of Copper With Different Valence States In Cu-Mcm-41

Hy Zhu,Bh Liu,Hl Zhang,Jy Shen
DOI: https://doi.org/10.3321/j.issn:1001-4861.2006.01.010
2006-01-01
Chinese journal of inorganic chemistry
Abstract:The Cu-MCM-41 mesoporous materials with different contents of Cu were synthesized. It was found that a reduction in the high temperature did not alter the mesoporous structure of the materials. The copper in walls of MCM-41 silica was easily reduced to Cu(0) in H-2, and a heat treatment in flowing He resulted in the reduction of Cu(II)) to Cu(I). The Cu(0) strongly adsorbed O-2 and the adsorption heat was up to 427 kJ(.)mol(-1), while Cu(I) did not adsorb O-2, at room temperature, indicating better stability of Cu(I) at ambient temperature. However, in the cases of the adsorption of CO and ethylene on Cu(I), apart from the adsorption heat for CO being nearly the same as that of Cu(O), the adsorption heat and the adsorption quantity on CA) were all higher. And the results of infrared spectra also showed that the cases of the adsorption of CO and ethylene on Cu(I) were easier than that on Cu(O). Adsorbed ethylene on Cu(O) was only via pi-bond while that on Cu(I) was via both di-sigma and pi-bonds. Due to the di-sigma bond strength being larger than the strength of pi-bond, the adsorption heat of ethylene on Cu(l) is higher.
What problem does this paper attempt to address?