Abstract:Lead-bismuth (Pb-Bi) alloys, as a superconducting material, have been widely studied at their superconducting transition temperatures and the critical magnetic fields for different composition ratios. Most of experimental studies focused on the stable ε phase formed at high temperatures, but less on the Pb-Bi alloys grown at low temperatures. So far, the structural and superconducting properties of the low-temperature Pb-Bi phases are far from good understanding. Here, we report our investigation of structural and superconducting properties of a low-temperature phase of Pb-Bi alloy. The Pb-Bi alloy films with a nominal thickness of about 6 nm are prepared by co-depositing Bi and Pb on Bi(111)/Si(111)-(7 × 7) substrates at a low temperature of 100 K followed by annealing at a treatment of 200 K for 2 h. The structural and superconducting properties of the Pb-Bi alloy films are characterized in situ by using low-temperature scanning tunneling microscopy/spectroscopy (STM/STS). It is observed that the spatially separated phases of nearly pure Bi(111) domains and Pb1–xBix alloy domains are formed in the films, where these phases can be identified by their distinct differences in the atomic structure and the distributions of step heights in the atomically resolved STM images, as well as by their distinguished STS spectra. The Pb1–xBix alloy phase presents the structure of Pb(111), in which about x ≈ 0.1 Bi is substituted for Pb. The STS spectra show that the Pb1–xBix alloy phase is superconducting, with a transition temperature Tc = 7.77 K derived from the variable-temperature measurements. This transition temperature is higher than that in pure Pb film (6.0–6.5 K), which can be well explained by the Mattias rules, with considering the fact that the average number of valance electrons increases after Bi atoms with five valance-electrons have been substituted for Pb atoms with four valance-electrons. The analysis shows that the ratio \begin{document}$ 2\Delta (0)/{k_{\rm{B}}}{T_{\rm{C}}}$\end{document} is about 4.94 with the superconducting gap \begin{document}$ \varDelta (0) = 1.66$\end{document} meV at 0 K, indicating that the Pb1–xBix alloy is a strongly-coupled superconductor. The non-superconducting Bi(111) and the superconducting Pb1–xBix alloy domains form an in-plane superconductor-normal metal-superconductor (S-N-S) Josephson junction. The proximity effect in the Bi(111) domains is measured at different N-S junctions, which suggests that the lateral superconducting penetration length in Bi(111) might be affected by the area of the quasi-two-dimensional interface. The superconducting gap in the Bi(111) region with a narrow width of 23 nm in an S-N-S Josephson junction is found to be greatly enhanced due to the existence of multiple Andreev reflections. Since Bi can host potential topological properties, the lateral Bi(111)-Pb1–xBix heterostructures, because of the existing proximity effect, could have potential applications in exploring the novel topological and superconducting phenomena.

J(C) Characteristics Of Bipbsrcacuo Silver Clamped Thick-Film

PREPARATION OF BiPbSrCaCuO SILVER CLAMP THICK FILM AND TRANSPORT CURRENT CHARACTERISTIC

Transport Critical-Current and Voltage-Current Characteristics of Bi(2223) Silver-Clamped Thick Films

MAGNETORESISTANCE IN Bi1.8Pb0.4Sr2Ca2Cu3Oy THICK FILM

Peculiar Property of Single Phase Bi 3 PbCa 3 Sr 3 Cu 4 O Y

Resistive upper critical magnetic field of a superconducting Bi-2201 thin film grown on a vicinal substrate

Enhanced Superconductivity Induced by the Hexagonal-Array-Cooling-Shrinkage Effect

Thermodynamic Fluctuations in Bi1.8Pb0.4Sr2Ca2Cu3Oy Thick Film

Thickness dependence of Jc (0) in MgB2 films

Resistive Transition of Bi(2223) Silver Clamped Thick-Film

THE STRAIN DEPENDENCE OF THE TRANSPORT CURRENT CHARACTERISTICS IN Bi-2223 SILVER CLAMPED THICK FILM

Magnetoresistivity below T-C in Silver-Clad Bi1.8pb0.4sr2ca2cu3oy Tape

Resistive Broadening Effect of Bi (2223) Silver Clamped Thick Film in Low Magnetic Field Range

Investigation of the Multilayer Deposited BiSrCaCuO Thin Films

Thickness Dependence of Critical Current Density in Mgb2 Films Fabricated by Hybrid Physical-Chemical Vapor Deposition

Comparison of J c measurements obtained by magnetisation and transport methods for a GdBCO-Ag bulk

Characterization of Structure and Superconducting Properties of Low-Temperature Phase of Pb-Bi Alloy Films

Thickness effect on pinning properties for GdBa2Cu3O7-x films deposited with RF sputtering

The Preparation and Characterization of Bi-2212 Film on Ag Substrate by Dip-Coating Method

Dimensional crossover in Bi1.8Pb0.4Sr2Ca2Cu3O y textured thick film

Phase purity and surface morphology of high-Jc superconducting Bi2Sr2Ca1Cu2O8+δ thin films