Abstract:Hydrogen is an efficient source of clean and environmentally friendly energy. However, because it is explosive at concentrations higher than 4%, safety issues are a great concern. As its applications are extended, the need for the production of reliable monitoring systems is urgent. In this work, mixed copper-titanium oxide ((CuTi)Ox) thin films with various copper concentrations (0-100 at.%), deposited by magnetron sputtering and annealed at 473 K, were investigated as a prospective hydrogen gas sensing material. Scanning electron microscopy was applied to determine the morphology of the thin films. Their structure and chemical composition were investigated by X-ray diffraction and X-ray photoelectron spectroscopy, respectively. The prepared films were nanocrystalline mixtures of metallic copper, cuprous oxide, and titanium anatase in the bulk, whereas at the surface only cupric oxide was found. In comparison to the literature, the (CuTi)Ox thin films already showed a sensor response to hydrogen at a relatively low operating temperature of 473 K without using any extra catalyst. The best sensor response and sensitivity to hydrogen gas were found in the mixed copper-titanium oxides containing similar atomic concentrations of both metals, i.e., 41/59 and 56/44 of Cu/Ti. Most probably, this effect is related to their similar morphology and to the simultaneous presence of Cu and Cu2O crystals in these mixed oxide films. In particular, the studies of surface oxidation state revealed that it was the same for all annealed films and consisted only of CuO. However, in view of their crystalline structure, they consisted of Cu and Cu2O nanocrystals in the thin film volume.

Amorphous Pb(Zr, Ti)O3 thin film hydrogen gas sensor

High Performance Hydrogen Sensor Based on Pd/TiO2 Composite Film

High-temperature Resistive Hydrogen Sensor Based on Thin Nanoporous Rutile TiO2 Film on Anodic Aluminum Oxide

Micro Hydrogen Sensor Based on Pd-Ag Nanofilm

Hydrogen Sensing Properties of an Aluminum-Doped Zinc Oxide Layer Decorated With Palladium Nanoparticles

igh-temperature resistive hydrogen sensor based on thin nanoporous rutile iO 2 film on anodic aluminum oxide

Flexible Hydrogen Sensor Based on Pd/TiO2 Nanofilm with Fast Response

A Study of MgZnO Thin Film for Hydrogen Sensing Application

Extraordinary Room-Temperature Hydrogen Sensing Capabilities of Porous Bulk Pt–TiO2 Nanocomposite Ceramics

Palladium and platinum thin films for low-concentration resistive hydrogen sensor: a comparative study

Study of a palladium nanoparticle/ In-Zn-O thin film-based hydrogen gas sensor

Study on hydrogen sensitivities of TiO2/PtO-Pt and SnO2/PtO-Pt dual-layer films

Development of Pd/TiO2 Porous Layers by Pulsed Laser Deposition for Surface Acoustic Wave H2 Gas Sensor

P-Type Hydrogen Sensing with Al- and V-doped TiO2 Nanostructures.

Hydrogen sensing of nanoporous palladium films supported by anodic aluminum oxides

A New Highly Selective H2 Sensor Based on TiO2/PtO−Pt Dual-Layer Films

Hydrogen Sensitivity Performance of Pd Doped SnO2 Nanostructured Film Fabricated by Spray Pyrolysis

Hydrogen Gas Sensing Properties of Mixed Copper-Titanium Oxide Thin Films

Pt=Pd Separation Modified Ti3C2TX MXene for Hydrogen Detection at Room Temperature

Pt1/4Pd Separation Modified Ti3C2TX MXene for Hydrogen Detection at Room Temperature

High-Selectivity Hydrogen Gas Sensors based on Mesoporous PbOx-ZnO Nanocomposites