Abstract:This article proposes a three-dimensional heterogenous-integrated (3DHI) switchable bandpass filter bank with two independent wideband filter channels that cover 26-40 GHz and 32.5-40 GHz, respectively. An accurate wafer-level process with a high hollowed ratio of the applied 8-inch high-resistivity-silicon (HR-Si) interposer wafers is presented to form both compact filter channels. Above the interdigital filter patterns fabricated on the bottom interposer wafer, deep cavities are etched in the cap interposer wafer to improve the quality factor of the filter bank. Besides the cavities, the cap interposer wafer is 35% hollow inside, which two bare dies of GaAs single-pole double-throw (SPDT) switches and two thin film resistors are attached to the bottom interposer after the wafer-to-wafer (W2W) bonding. To ensure good out-of-band performance, a 3D EM co-simulation of the switch layout at the chip level and filter patterns at the package level is applied. Measurement results show that the switchable filter bank achieves a high isolation of 50 dB and a competitive shape factor (BW30dB/BW3dB) of about 1.3. In addition, the size of the switchable filter bank is only 7.0 mm x 3.5 mm x 0.6 mm, and the weight is only 0.1 g.

3 Kw Completely-Integrated EMI Filter Based on Flexible Multi-layer Foil

Design and Experiment Research of Integrated EMI Filter Based on Flexible Multi-Layer Foils

An Optimization Design of Output Filter in a Grid Connected Inverter With Flexible Multilayer Foil Technique

Design, Modeling, and Improvement of Integrated EMI Filter With Flexible Multilayer Foils

Principles and design on integrated EMI filters

Integrated EMI filter design with flexible PCB structure

An Integrating Structure of EMI Filter Based on Interleaved Flexible Multi-Layer (FML) Foils

Integration of Both EMI Filter and Boost Inductor for 1-Kw PFC Converter

An Integrating Structure of Output Filter for Grid Connected Inverter Based on FMLF Technique

A PFC Converter With Novel Integration of Both the EMI Filter and Boost Inductor

PFC converter with novel integration of both EMI filter and Boost inductors

EMI Filter Design Based on High-Frequency Modeling of Common-mode Chokes

Design of compact dual-band quasi-elliptic filter with high selectivity and wide stopband rejection

A Novel Multilayer Partial H-Plane Filter Implemented with Folded Substrate Integrated Waveguide (FSIW)

A Novel Surface-Mounted Monoblock Dielectric Filter

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

Modeling of Integrated EMI Filter with Flexible Multi-Layer (FML) Foils

High Power Density Three-Phase Shunt Active Power Filter Design Based on Multiple Magnetic Integrations of Lcl Filter

An Optimization Design for Transformer and Output Filter of a Micro-inverter with Passive Integration Technique

An Improved Foster Model of Common-Mode Inductor and Its Application in EMI Filter Design