Abstract:Inelastic transient finite element simulations based on an actual truck collision test are used to investigate the demands imposed during collisions between medium-duty trucks and anti-ram bollards constructed with concrete-filled steel tubes (CET). The medium-duty truck is considered for crashing into a bollard at speed 50, 65, and 80 km/h, respectively, based on performance demands of bollards of different grades. Numerical results show that both the impact force and the bollard deflection increase with increasing the truck impact speed. When the speed is relatively high (e.g. 80 km/h), there is a risk of the truck climbing over the bollard, even with little damage to the bollard. The analyses show that the impact force along the height of the bollard is not uniform and may change during the impact process. Considering the complexity and computation time consumption, a simplified analysis based on a two-degree-of-freedom mass-spring-damper system model is developed to simulate the collision process. In the analysis, a bilinear spring is used to characterize the truck considering its "soft front and hard rear" characteristics when impacting bollards. Results show that the simplified analytical model is in good agreement with the finite element model using a detailed truck model. (C) 2014 Elsevier Ltd. All rights reserved.

Numerical model development for an expanding-tube seat-bumper in a spacecraft

Numerical Simulation and Structure Optimization of Compressor Muffler

Simulation and Characteristic Analysis of Hydraulic Bumper

Numerical Analysis of Acoustic Characteristic of Muffler with Complicated Structure and Structural Optimization

Numerical Simulation and Test for a Turbine Damper

Test and Numerical Simulation of Truck Collision with Anti-Ram Bollards

Dynamic Model for the Seat-Bumper System Reducing the Manned Spacecraft Landing Impact

A Bumper Model with Dynamic Contact Stiffness for Simulations of Pedestrian Legform Impacts

Data-driven lightweight design of bumper based on multi-methods

Simplified finite element modeling method and separation dynamics of large scale fairing structure

Numerical Study of Section Geometry of Flexible Bag of Air Cushion Vehicle Subjected to Slamming Loads

Numerical Simulation and Sequence Optimization on the Welding Process of Aluminum Alloy Vehicle Bumper

Modelling and simulation of a sandwiched tube-type airbag and its optimization using design of experiments

Simulation and Optimization on the Injection Molding for Auto-Bumper

Crashworthiness Analysis and Multi-Objective Optimisation of a Novel Circular Tube under Three-Point Bending

Design Method for Expandable Tubular Energy Absorber in Crashworthy Seat of Civilian Helicopter

Car Bumper Structure Design for Improving Crashworthiness

Developing a simplified finite element model of a car seat with occupant for predicting vibration transmissibility in the vertical direction

Dynamical analysis and simulation of parallel bumper for INS

Using Nonlinear FEM Simulation to Optimize Design of Skirt Joints on the Plenum Walls of Air Cushion Vehicles

Simulation Analysis of Inner Force Characteristics of Car Body Thin-walled Beam Structures Subject to Lateral Impact