Abstract:Hypervelocity impacts on spacecraft in low earth orbit by meteoroids and space debris poses a threat to space missions, and the use of a shield can significantly decrease the probability of a catastrophic failure. Aluminum foam is a new type of material for shield of spacecrafts for it bears favorable characteristics when subjected to hypervelocity impact of space debris. An Al-foam Sandwiched Shield and an Al-foam Stuffed Shield were presented under the concept of light-weight shield structure and their shield performances were compared through hypervelocity impact experiments using two-stage light gas gun. The base materials of the open-cell foam used were Al-Si alloy ZL102 and pure aluminum respectively. The total bumper areal density, rear wall excluded, was about 0.8g/cm 2 for most shields tested. The projectile launched was 2017 aluminum sphere with its diameter fixed to be 3.97mm and the impact velocity was between 2.6-6.3km/s with a 0 degree incident angle. The damages of the bumpers included and the rear wall were examined thoroughly after impact and compared to each other to evaluate the shield performance of different configurations and the influence of different base materials as well. The experimental results indicated that within the speed range tested, the Al-foam Stuffed Shield has significantly better performance than the Al-foam Sandwiched Shield. And for a same shield configuration, the base material of Al-Si alloy used can provide slightly better performance than that of pure aluminum. Copyright ©2010 by the International Astronautical Federation. All rights reserved.

Numerical Simulation Investigation in Hypervelocity Impact on Al-foam Stuffed Shields

Numerical Simulation Investigation in Hypervelocity Impact on Shield Structure Containing Aluminum Foam

Numerical Simulation in Effect of Geometrical Parameters of Al-foam on Performance of Stuffed Shields

Experimental comparison of Al sphere hypervelocity impact on Al-foam sandwiched shield and Al-foam stuffed shield

Distribution of debris cloud caused by hypervelocity impact on AL-foam shield

Numerical Simulation Investigation in Ballistic Limit of Whipple Shield Structure with Al-foam Bumperb

Performance of different metal-foam stuffed whipple shield against hypervelocity impact of space debris

Experimental research on performance of al-foam stuffed whipple shield against hypervelocity impact

Numerical Simulation Investigation in Behavior of Al-Foams Structure under Hypervelocity Impact

Behavior of Aluminum Foams under Hypervelocity Impact: Validation of Numerical Simulation

Investigation into damage of Al-foam stuffed whipple shield under hypervelocity projectiles impact

Numerical Investigation on Dynamical Response of Aluminum Foam Subject to Hypervelocity Impact with Material Point Method

Numerical Study of Dynamic Behavior of Foams Subjected to High- to Hyper-Velocity Impact

Comparison of shielding performance between Al-foam and solid-aluminum bumpers with numerical simulation

Ballistic Limit Analysis of Aluminum 5A06 Single Wall Plate Subjected to Hypervelocity Impact

Experimental Study on the Behavior of a New Multilayer Shield against Hypervelocity Debris Impact

Investigation into Damage of Aluminum Multi-Wall Shield under Hypervelocity Projectiles Impact

Numerical Studies on Ballistic Limit and Cellular Dispersion of Aluminium Foam Sandwich Panel under Hypervelocity Impact

Numerical Simulation of Non-Spherical Projectiles Hypervelocity Impact on Spacecraft Shield Configuration

Modeling of Hypervelocity Impact of Sandwiched Open Cell Aluminum Foam

Simulation for fragment debris impacting composite shield in hypervelocity