Abstract:The temperature field distribution during the growth of crystalline silicon by the directional solidification (DS) method is an important factor affecting the growth rate, the shape of the melt-crystal (m-c) interface, and thermal stress. To solve the problem of m-c interface convexity at the early stage of crystal growth caused by supercooling at the bottom center of silicon ingot during DS. In this paper, a two dimensional (2D) global transient numerical model based on a large-size ALD-G7 (G7) crystalline silicon ingot furnace is established and experimentally verified. Based on the model, the influence of different bottom thermal gate moving process curves on the convexity of the m-c interface at the early stage was studied, with emphasis on the changes in temperature field, m-c interface, and thermal stress at the early stage of crystal growth. We have designed three cases, case 1 uses the original moving process curve of bottom thermal gate, case 2 and case 3 adjust the process curve to 0.95 and 0.9 of the original ratio, respectively. The numerical simulation results show that compared with case 1, the average heat dissipation at the bottom of the silicon ingot in case 2 and case 3 is reduced by 2.7 kW·m −2 and 4 kW·m −2 , and the maximum thermal stress is also reduced by 3 MPa and 4 MPa, separately. The maximum convexity of the interface is reduced by 25 mm and 20 mm, and the convexity is reduced by 55% and 44% on average, respectively.

Simulation for Temperature Distribution of Polycrystalline Silicon Casting Process

Numerical Simulation of Directional Solidification Process for the Polycrystalline Silicon Ingot

Numerical Simulation of Radiative Heat Transfer in 24 Pairs of Rod Polysilicon Reduction Furnace

Simulation of temperature field of sintering ignition furnace

System design and hot zone optimization of monocrystalline silicon directional solidification furnace for PV application

Simulation to confirm the existence of distinct low-temperature regions in a Si melt using an insulating plate under the crucible bottom for the noncontact crucible method

Optimization of the Thermal Field of 8-Inch SiC Crystal Growth by PVT Method with “3 Separation Heater Method”

Thermal system design and optimization of an industrial silicon directional solidification system

Numerical Simulation for Temperature Field of Electron Beam Melting Polysilicon

Influence of Radiation Heat Transfer on Mc-Si Ingot during Directional Solidification: A Numerical Investigation

Numerical simulation of flow and heat transfer in a novel polysilicon reduction furnace

Numerical analysis of thermohydraulic behavior in a directional solidification furnace

Simulation of Temperature Field and Microstructure in Heavy Steel Ingots Solidification

Numerical and experimental investigation of octagonal thermal field for improving multi-crystalline silicon ingot quality

Modeling and improvement of silicon ingot directional solidification for industrial production systems

Investigation of heat transfer mechanism affecting temperature homogeneity at polysilicon rods in a Siemens reduction furnace

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

Role of Longitudinal Temperature Gradients in Eliminating Interleaving Inclusions in Casting of Monocrystalline Silicon Ingots

Effect of Silicon Nitride Coated Carbon Crucible on Multi-Crystalline Silicon Ingot during Directional Solidification Process: Numerical Simulation

Numerical Investigation on the Effect of Thermal Gate Moving Rate on Directional Solidification Process

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer