Abstract:A multiphase lattice Boltzmann model is developed to simulate immiscible thermocapillary flows with the presence of fluid–surface interactions. In this model, interfacial tension force and Marangoni stress are included by introducing a body force term based on the concept of continuum surface force, and phase segregation is achieved using the recolouring algorithm proposed by Latva-Kokko and Rothman. At a solid surface, fluid–surface interactions are modelled by a partial wetting boundary condition that uses a geometric formulation to specify the contact angle, and a colour-conserving boundary closure scheme to improve the numerical accuracy and suppress spurious velocities at the contact line. An additional convection–diffusion equation is solved by the passive scalar approach to obtain the temperature field, which is coupled to the hydrodynamic equations through an equation of state. This model is first validated by simulations of static contact angle and dynamic capillary intrusion process when a constant interfacial tension is considered. It is then used to simulate the thermocapillary migration of a microfluidic droplet on a horizontal solid surface subject to a uniform temperature gradient. We for the first time demonstrate numerically that the droplet motion undergoes two different states depending on the surface wettability: the droplet migrates towards the cooler regions on hydrophilic surfaces but reverses on hydrophobic surfaces. Decreasing the viscosity ratio can enhance the intensity of thermocapillary vortices, leading to an increase in migration velocity. The contact angle hysteresis, i.e., the difference between the advancing and receding contact angles, is always positive regardless of the contact angle and viscosity ratio. The contact angle hysteresis and the migration velocity both first decrease and then increase with the contact angle, and their minimum values occur at the contact angle of 90 degrees.

Numerical Simulation of Thermocapillary Flow Induced by Non-Uniform Evaporation on the Meniscus in Capillary Tubes

Numerical Simulation and Experimental Study of Capillary Tubes

Numerical investigation of heat and mass transfer from an evaporating meniscus in a heated open groove

Evaporation-driven thermocapillary Marangoni convection in liquid layers of different depths

An analysis of flow characteristics during ethanol natural evaporation in capillary tubes with varying diameters

Thermocapillary flow transition in an evaporating liquid layer in a heated cylindrical cell

Simulation Of Single Bubble Evaporation In A Microchannel In Zero Gravity With Thermocapillary Effect

Transport from a Volatile Meniscus Inside an Open Microtube

Transport From a Volatile Meniscus in a Microtube

Modelling thermocapillary migration of a microfluidic droplet on a solid surface

Unexpectedly absence of Marangoni convection in an evaporating water meniscus

A Numerical Investigation on Micro Particle Dynamics Near an Evaporating Meniscus

Capillary-assisted Flow and Evaporation Inside Circumferential Rectangular Micro Groove

An energy-conservative many-body dissipative particle dynamics model for thermocapillary drop motion

Capillary flow of evaporating liquid solutions in open rectangular microchannels

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Numerical Gas-Liquid Stratified Flow Regime Model On Evaporation Heat Transfer In Horizontal Microfin Tubes

Modeling and Simulation of Thermocapillary Flows Using Lattice Boltzmann Method

Thermocapillary migration of a planar droplet at moderate and large Marangoni numbers

Numerical Study of Thermocapillary Migration Behaviors of Droplets on a Grooved Surface with a Three-Dimensional Color-Gradient Lattice Boltzmann Model

Internal Flow in Evaporating Droplet on Heated Solid Surface