Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

EXPERIMENTAL STUDY ON THE SINGLE-PHASE FLOW AND HEAT TRANSFER OF LIQUID NITROGEN IN MICRO-TUBES

Experiment for influence of boiling surface on critical heat flux in liquid nitrogen pool boiling

An Experiment-Based Comparative Investigation of Correlations for Microtube Gas Flow

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Transitional And Turbulent Convective Heat Transfer Of Compressible Gas Flows Through Microtubes

Single Phase And Two Phase Flow Characteristics And Heat Transfer In Micro-Fin Tubes

The Effect on the Nusselt Number of the Nonlinear Axial Temperature Distribution of Gas Flows Through Microtubes

Investigation of Convective Heat Transfer with Liquids in Microtubes

Experimental and numerical investigation of forced convection of subsonic gas flows in microtubes

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Experimental Investigation On Flow Condensation Heat Transfer In Microtube

Experimental study on flow characteristics of liquid in circular microtubes

Experimental Study of Single-Phase Pressure Drop and Heat Transfer in a Micro-Fin Tube

Two-Phase Flow Heat Transfer In Micro-Fin Tubes

Experimental Study on Forced Convective Heat Transfer of CNT Nanofluids in Microtube

Numerical Investigation On The Effect Of Roughness On The Flow Resistance For Incompressible Fluid Flow In Microtubes

Prediction of Friction Factor and Heat Transfer Coefficient for Single-Phase Forced Convection Inside Microfin Tubes

Experimental Analysis of Gas Flow Forced Convection in Microtubes

Flow boiling of liquid nitrogen in a horizontal macro-tube at low pressure: Part I - flow pattern, two-phase flow instability, and pressure drop