Abstract:Scheme of porous PVA hydrogel preparation and investigation of adsorption performance to Congo red. In this work, porous poly (vinyl alcohol) (PVA) hydrogels with different pore sizes were fabricated using inorganic non‐metallic porogens by an environmentally friendly method, providing a potential solution for the field of wastewater treatment. PVA hydrogels have gained much attention in the field of wastewater treatment due to their excellent adsorption performance and porous network structure. However, the employment of inorganic non‐metallic salts as porogens for PVA hydrogels has received limited attention so far. In this study, porous PVA hydrogels were prepared by freeze‐thawing and freeze‐drying with sodium sulfate (Na2SO4) and calcium carbonate (CaCO3) as porogens. PVA‐Na exhibited denser network structure with the concentration of Na2SO4 solution increased, and the tensile stress was enhanced by about 45 times. Meanwhile, the tensile stress of PVA‐Ca was improved significantly from 0.06 to 1.67 MPa, and the network structure became looser after adding CaCO3. Moreover, a comprehensive investigation was conducted on the adsorption performance of porous PVA hydrogel for Congo red (CR). Finally, five adsorption models were fitted to investigate the adsorption mechanism of porous PVA hydrogels, in which the maximum adsorption capacity of CR by PVA‐Na‐0.5 was predicted to be 215 mg/g by the Langmuir isothermal model fitting. Highlights The structure of PVA hydrogels was adjusted by Na2SO4 and CaCO3, respectively. The tensile stress of PVA‐Na with dense network structure increased 45 times. Compared to PVA‐FD, swelling equilibrium time of PVA‐Na reduced from 24 to 6 h. Equilibrium swelling rate of PVA‐Ca declined by half in comparison to PVA‐FD. Langmuir isothermal model predicted qmax of 215 mg/g for CR by PVA‐Na‐0.5.

Study on polyvinyl alcohol induced microorganism immobilization in porous silicon carbide

Experimental Study on Surface Modification of Porous Silicon Carbide and Biocompatibility

Immobilization of Activated Sludge in PVA Matrix Using Innovative Methods

Immobilization of activated sludge using improved polyvinyl alcohol (PVA) gel

The influence of poly-vinyl-alcohol (PVA) characteristics on the physical stability of encapsulated immobilization media for advanced wastewater treatment

Immobilization of microorganisms with phosphorylated polyvinyl alcohol (PVA) gel

Study on Preparation and Properties of PVA‐SA‐PHB‐AC Composite Carrier for Microorganism Immobilization

Study on Polyvinyl Alcohol (PVA) As Entrapping Agents for Immobilizing Microbial Cell

Immobilization of Powdery Calcium Silicate Hydrate Via PVA Covalent Cross-Linking Process for Phosphorus Removal.

Study on the immobilization of bacillus subtilis with multi-carrier of PVA

Characterization and Comparison of Anammox Immobilization in Polyvinyl Alcohol, Polyethylene Glycol and Water-Borne Polyurethane

Immobilization of Microbial Cells Using Polyvinyl Alcohol (PVA) — Polyacrylamide Gels

Conditions of Imbedded Immobilization for the Treatment of Methanol Wastewater by Immobilized Microorganism

Protection of methanogenic bacteria from low pH and toxic materials by immobilization using polyvinyl alcohol

Optimized Immobilization of Activated Sludge in Poly(ethylene Glycol) Gels by UV Technology

Comparison of Microbial Activity of Activated Sludge Immobilized in Polyvinyl Alcohol Gel by Various Reagents

Enhanced efficacy of nitrifying biomass by modified PVA_SB entrapment technique

Preparation of crosslinked macroporous PVA foam carrier for immobilization of microorganisms

Pore structure evolution and adsorption behaviors of porous poly (vinyl alcohol) hydrogel prepared using Na2SO4 and CaCO3 as porogens

Toughening of Polyvinyl Alcohol Hydrogel Through Co-Crosslinking and its Wastewater Treatment Performance by Immobilizing with Microorganism

PVA-immobilized beads modified by carrageenan and bentonite