Abstract:Electro-reduction of O2 to generate H2O2 is an attractive alternative to the current anthraquinone process and quietly necessary for the chemical industries and environmental remediation. It is general that sufficient porous structure contributes to expose more catalytic active sites and shorten diffusion paths for the heterogeneous catalysis of O2. In this work, initially, the Fe3O4 nanoparticles embedded graphite felt (Fe3O4@GF) is prepared through a mild hydrothermal following with thermal reduction method. This special combination not only provides iron source for the electro-Fenton reaction, but also supplies rich active sites from the Fe3O4 embedded structure with abundant cracks, which are beneficial to increase the reaction rate. Compared with raw graphite felt (RGF), the fresh Fe3O4@GF exhibits superior pollutant degradation kinetics with more than 400% increase and approximately 37.8% improvement to the removal of total organic carbon. 98% decolorization of rhodamine B (RhB) can be achieved in just 5 minutes, and quickly complete 100% removal of RhB in the next few seconds. As the electro-Fenton reaction progresses, Fe3O4 dissolves in the electrolyte, leaving porous structure on the surface of the GF to form a porous GF (PGF), and the rapid radical reaction activates GF surface. Both the chemical etching of Fe3O4 and the electro-Fenton process can further increase the specific surface area, defects and actives sites of the electrode. As expected, the active PGF exhibits favorable performance of H2O2 production among in pH=1 (320.0±36.5 mg L-1), 3 (301.9±13.2 mg L-1) and 7 (320.4±21.2 mg L-1) electrolyte. The degradation performance of PGF does not significantly decay even after 20 times repeated use, indicating the good structural stability and long-term durability. The superiority of the in-situ Fe source and fast reaction kinetics for electro-Fenton of Fe3O4@GF is confirmed, and this holey-engineered strategy also provides the possibility to achieve swift water purification and open up a new way for developing efficient carbon-based electrodes.

Fe-modified Multi-walled Carbon Nanotube Electrode for Production of Hydrogen Peroxide

Enhancing the Production of Hydrogen Peroxide from Electrocatalytic Oxygen Reduction Reaction by Tailoring the Electronic States of Single-Walled Carbon Nanotubes: a Synergistic Effect from Interior Filling and Exterior Oxidation

In Situ Generation of Hydrogen Peroxide Using Polymetallic-Doped G-C3n4 for Pollutant Removal

A Nitrogen Functionalized Carbon Nanotube Cathode for Highly Efficient Electrocatalytic Generation of H2O2 in Electro-Fenton System

Simultaneously Providing Iron Source towards Electro-Fenton Process and Enhancing Hydrogen Peroxide Production via a Fe3O4 Nanoparticles Embedded Graphite Felt Electrode.

Integrated and Superaerophilic Ni-O-C Electrode enables Fast and Stable Electrochemical H2O2 Production for Electro-Fenton-like Process

Construction of a cathodic MOF/FeOOH heterojunction for boosted Fe(III) reduction in electro-Fenton processes

Modified Cathodes with Carbon-Based Nanomaterials for Electro-Fenton Process

Vertically Aligned Carbon Nanotube-Based Electrodes for Hydrogen Production by Water Electrolysis

Preparation of a Highly-Efficient Electro-Fenton Cathode Material for H2O2 Generation and Its Electrochemical Performance in COD Removal

Electro-generation of Hydrogen Peroxide by an Activated Carbon Fiber Cathode:Influencing Factors and Mechanisms

Co‐MOF-Derived Flake-Like Co3O4 Supported Pd Nanoparticles as High-Performance Hydrogen Peroxide Electroreduction Catalysts

Accelerated Fe(II) regeneration on Fe-doped oxidized carbon nanotube enabling highly-efficient electro-Fenton process for pollutants removal

Activated carbon filled in a microporous titanium-foam air diffusion electrode for boosting H2O2 accumulation

Fabrication of a double-layer membrane cathode based on modified carbon nanotubes for the sequential electro-Fenton oxidation of p-nitrophenol

In situ semi-etching of bimetallic LDH nanosheet arrays into FeNi-LDH/MOF to boost oxygen evolution reaction

Highly efficient electrosynthesis of hydrogen peroxide through the combination of side aeration and vacuum filtration modified graphite felt

Improving the yield of hydrogen peroxide on gas diffusion electrode modified with tert-butyl-anthraquinone on different carbon support

Electrochemical Synthesis of Hydrogen Peroxide Catalyzed by Carbon Nanotubes with Surface Co-NX Sites and Encapsulated Co Nanoparticles

Electrochemical behavior of electrodes modified with metalloporphyrin and multiwalled carbon nanotubes for the reduction of oxygen, proton and carbon dioxide

Novel Gas Diffusion Electrode System for Effective Production of Hydrogen Peroxide