Abstract:Helical groove of end mill has great influence on its cutting performance. It is normally ground by disk wheels and the groove geometry varies with different wheel geometries. To improve the machining accuracy and reduce the cost of the groove machining process, establishing the groove model with the known wheel geometry and the wheel movement locus before the actual grinding is necessary. In this paper, according to the characteristics of wheel geometry, two different methods are introduced to build the groove model. One is based on the enveloping theory, taking into account the fact that the groove is generated by the enveloping movement of the wheel. Contact lines between the wheel and the groove are firstly deduced. Then, the expressions of the groove and the groove section lines are obtained. This method works well for wheels with straight generatrices. However, if the generatrix consists of quadric curves, a complex transcendental equation needs to be solved to satisfy the enveloping condition. Thus, the other modified graphical method is needed. The wheel is expressed in piecewise. During the grinding process, every part of the wheel will form a family of surfaces. By solving the intersections of these families and the end mill cross-section plane, a point set is obtained. Obviously, the outline of the set is the groove section line. Using this method, the result will be a set of points, but it has no wheel geometry limitation. The calculation procedures of these two methods are programmed with the MATLAB language and have good agreements with the Boolean result.

The General Geometrical Models of the Design and 2-Axis Nc Machining of A Helical End-Mill with Constant Pitch

Study on Geometric Models of Non-Numerically Controlled Machining Revolving Cutter with Constant Pitch

Design Method and Numerical Control Machining Principle for an Arbitrary N-Polygon Noncircular Section

The Several Problems in the 2-Asis NC Machining of the Revolving Cutters

Instructions About 2-axis NC Machining of Ball-end Milling Cutters

Two Problems Concerning 2-Axis NC Machining Using Toroid-Shaped Revolving Cutter and Their Solutions

Design of a CAM System for End Mills Based on Solid Modeling

Geometric characteristics analysis and parametric modeling for screw rotor precision machining

Modelling Methods for End Mill Grooves Based on Different Wheel Geometries

A Manufacturing Model for Ball-End Mill Gashing Based on a CAM System

Mathematical Modeling and Parametric Design of Taper End Mills

An accurate mathematical model for ball end mills with chisel edge

Development Of An Integrated System Of Geometric Modeling And Machining Simulation Of End Mill

A General Mathematical Model for Two-Parameter Generating Machining of Involute Cylindrical Gears

Geometric Modeling and Optimal Design of a New Micro Ball-End Mill

Proposition of New Gear Cutting Method Using by General Purpose Tool

Geometry Simulation and Evaluation of the Surface Topography in Five-Axis Ball-End Milling

Kinematics modeling and trajectory optimization for precision grinding of variable-parameter helical grooves

Cutting Edge Curve Models for Equal Pitch Cutters and Their Applications

The Machining Principle and Modeling of Conical Screw with Continuous Grading Lead

Geometrical Contour Evaluation Models for Toroidal Milling Cutters with Taper Datum Shanks